Technical Data - URSUS TROTTER UT-REIN17SS Manual De Usuario Y Letra De Garantía

4. Replace the lid and place the kettle back on the power
base. Make sure the lid is securely fitted on the kettle
before boiling.
5. Position the kettle on the power base.
6. Plug the power base into the power outlet and switch
on at the mains.
7. To start boiling press the ON/OFF switch to the down
position.
8. The power indicator will illuminate and the kettle will
start to boil. NEVER REMOVE THE LID DURING BOILING.
9. When the water has boiled the kettle will switch off
automatically and the power indicator will extinguish.
10. You can stop the boiling process at any time by
pressing the switch to the OFF position.
11. After the kettle has switched off automatically, there
may be a short delay before it can be re-boiled. This is
usually no more than 20 seconds.
12. The safety cut-out will operate if you accidently
switch on the kettle when it is empty or allow it to boil
dry Wait 15 minutes for the cut-out to reset before
refilling with cold water and boiling.
Cleaning
1. Always unplug the kettle from the mains supply and
allow to cool down completely before storing or cleaning.
2. Never immerse any part of the power cable, plug,
power base or kettle in water or any other liquid.
3. Wipe the exterior of the kettle using a damp cloth.
Dry thoroughly. Never use harsh chemicals or abrasive
cleaning agents as these may damage the finish of your
kettle.
4. Over a period of time lime scale can build up inside
your kettle. To remove lime scale half fill the kettle with
water and add the juice of a lemon. Boil the kettle and
allow to stand for 15 minutes before discarding. Repeat
several times using cold water only.
Safety, as insertion into a 13 amp socket could cause an
electrical hazard.

TECHNICAL DATA:

Rated Voltage: AC 220-240V ~ 50/60Hz
Power: 1800-2150W
Capacity: 1.7L