Extension Cords - Genesis GLSN08B Manual Del Operario

Store idle tool out of reach of children and other inexperienced persons
•
dangerous in the hand of untrained users.
Maintain power tools with care
•
component breaks, and any other conditions that may affect the tool's operation. A guard or any other part that
is damaged must be properly repaired or replaced by an authorized service center to avoid risk of personal
injury.
Use recommended accessories
•
manufacturer or intended for use on this type tool may cause damage to the tool or result in personal injury to
the user. Consult the operator's manual for recommended accessories.
Keep cutting tools sharp and clean
•
are less likely to bind and are easier to control.
Feed the workpiece in the correct direction and speed.
•
blade, cutter, or abrasive surface against the direction of the cutting tool's direction of rotation only. Incorrectly
feeding the workpiece in the same direction may cause the workpiece to be thrown out at high speed.
Never leave the tool running unattended, turn the power off
•
until it comes to a complete stop.
BATTERY TOOL USE AND CARE
Ensure the switch trigger is in the off position before inserting battery pack.
•
Inserting the battery pack into a power tool that has the switch on invites accidents.
recharge only with the charger specified by the manufacturer.
•
suitable for one type of battery pack may create a risk of fire when used with another battery pack.
Use battery tools only with specified battery packs
•
create a risk of injury and fire.
Avoid storing the battery pack in a container with other metal objects such
•
as nails, coins, clips, keys, screws, or other small metal objects that can
make a connection from one terminal to another
when battery pack is not being used. Connecting the battery terminals together may cause burns or a fire.
Under abusive conditions, liquid may be ejected from the batter
•
If contact accidentally occurs, flush with water. If liquid contacts eyes, additionally seek medical help. Liquid
ejected from the battery may cause irritation or burns.
Battery tools do not need to be plugged into an electrical outlet
•
are always in an operation condition. Be aware of possible hazards when not using your battery tool or when
changing accessories. following this rule will reduce the risk of electric shock, fire or personal injury.
SERVICE
• Have your power tool serviced by a qualified repair person
replacement parts. This will ensure that the safety of the power tool is maintained.
• Service your power tool periodically.
portion of the tool since internal wires may be misplaced or pinched.
WArNING:
OPErATING INSTrUCTIONS BEFOrE USING THIS EQUIPMENT. Failure to follow all
instructions listed below may result in electric shock, fire and/or serious personal injury.

EXTENSION COrDS

Grounded tools require a three wire extension cord
use either a two or three wire extension cord. As the distance from the power supply outlet increases, you must
use a heavier gauge extension cord. Using extension cords with inadequately sized wire causes a serious drop
in voltage, resulting in loss of power and possible tool damage. refer to the table shown below to determine the
required minimum wire size.
The smaller the gauge number of the wire, the greater the capacity of the cord. for example: a 14-gauge cord
can carry a higher current than a 16-gauge cord. When using more than one extension cord to make up the total
length, be sure each cord contains at least the minimum wire size required. If you are using one extension cord for
4
. Check for proper alignment and binding of moving parts,
. Using accessories and attachments not recommended by the
rEAD AND UNDErSTAND ALL WArNINGS, CAUTIONS AND
8V Lithium-ion Stapler/Nailer
Operator's Manual
. Properly maintained cutting tools with sharp cutting edges
. Use of any other battery packs may
. Always protect the battery terminals
When cleaning a tool, be careful not to disassemble any
GLSN08B
. It is
feed the workpiece into a
. Do not leave the tool
A charger that is
y. Avoid contact.
, therefore, they
using only identical
.
Double insulated tools can