Guardian G1-201LBX1 Manual De Instrucciones Para El Usuario Y Garantía página 3

LEG HEIGHT ADJUSTMENT
Before using the commode, make sure all legs are set to the same preferred height.
1. To adjust leg height, depress pushbutton and slide each leg to the desired height
by aligning with proper holes and letting the pushbutton snap into the correct
hole. (Figure 2)
2. Repeat until all legs are adjusted to the preferred height.
3. Make sure legs are locked into place by pushing down and pulling up on each leg.
CAUTIONS:
Users with limited physical strength and/or mobility should be supervised and/or
assisted while using the product.
Prior to use, ensure the following:
1. Toilet seat must be in the down position before use. Failure to do so may results
in possible injury or damage.
2. All push buttons are fully protruded and are properly engaged.
3. There are no loose, broken or missing components and ensure all parts are
secure.
4. When using the backrest, ensure the commode remains balanced. Excessive
twisting or turning while seated on the commode may cause a loss of balance
and/or damage to the product.
5. Tips on the extension legs do not contain rips, cracks or are excessively worn.
Immediately replace missing or damaged tips.
6. All four legs touch the floor simultaneously at all times.
7. User evenly distributes weight between the arm supports when transferring in
and out of the commode.
MAINTENANCE
Periodic visual inspection of this commode is recommended to ensure that all
parts and hardware are secure, that components are in good working order and not
worn, torn, frayed, or loose, and that there are no obstructions or impediments to
normal, safe operation. If any part or mechanism appears to be unsafe or damaged,
do not use the product. If you experience problems, please contact Medline at
1-800-MEDLINE.
CLEANING
• Clean with regular household cleaning products. Use a non-abrasive cleaner
with warm water. Wipe dry after cleaning.
• DO NOT use abrasive powders, cleaners or scouring pads.
Figure 2
G1-201LBX1 (PIC-00244)
REVISED: 05/20/21