Mopar Jeep Wrangler 2007 Instrucciones Para La Instalación página 8

LED
J. Drill 9/32" hole in trim panel as
shown in diagram. Exact place-
ment needs to be determined
before drilling. Ensure there is
nothing on the backside of the
panel and there is enough depth for
the LED.
K. Route the remaining Dk Green wire
through the cowl panel and into the
engine compartment through an existing
grommet.
Horn Connections
L. Locate the Grey/Yellow (X21) wire in the
green "C" connector (pin #18) found
underneath the TIPM module. Center-
splice the relay harness Grey wire (pin
30) into this wire, following the center-
splice procedure. Solder the connection.
This wire will show +12V when the horn
is activated.
M. Connect the relay harness Red wire (pin
87) to the positive battery post.
N. Route the remaining relay harness Dk
Green wire (pin 85) to the Dk Green (-)
HORN output wire on the main security
harness. Solder the connection.
8