Publicidad
Idiomas disponibles
Idiomas disponibles
15. Attach other end of linkages #4 to OUTSIDE of U-support #7 with
bolts #14 and plastic washers #24. Then slide name panel #5 onto the
same bolts #14 on the INSIDE of U-support #7. Secure with lock nuts
#15 See Figure 5B. Tighten hardware until snug but do not
overtighten. Tubes must pivot freely.
16. Attach bottom of name panel #5 to U-supports #7. Secure with
hex bolts #9 and locknuts #15. Tighten nuts but be careful not
to crush tubes. See Figure 5B.
17. Attach bottom board #33 to name panels #5,
as shown in Figure 5B, using four bolts #32
and four hex nuts #15.
18. Prepare an area for the assembly of the second table top half. If necessary, move the first
table top half aside with the aid of a helper. Be sure to place it in a location where it
won't be disturbed or damaged. If setting on its side, be sure to place the bottom edge
no less than 12 inches away form the wall. Also be sure to place carpet or pieces of the
shipping carton down to protect table top edges. If floor is not carpeted, brace table top
half with a heavy object to keep it from sliding.
15
9
24
14
15
4
First Table Top
Figure 5B
Figure 3
Figure 3
7
CAUTION:
AT LEAST TWO ADULTS ARE NEEDED
TO MOVE TABLE HALF!
5
32
7
33
15
5
32
9
24
14
15
4
Publicidad
