Epson ELPMBP04 Instrucciones De Instalación página 8

ELPMBP04
TRAY INSTALLATION
1. Reinstall ceiling tile with extension column hole. Ensure tile
is oriented for proper location of hole.
2. Reinstall ELPMBP04 assembly (A) on top of ceiling tile so
that extension column support is centered over hole in tile.
3. Position ELPMBP04 assembly (A) with four screws (G) as
required:
• For 24" (610mm) Framework: Install screws through
end bracket inside holes (See Figure 7).
• For 600mm (23-5/8") Framework: Install screws
through end bracket outside holes (See Figure 8).
24" (610mm)
Figure 7
600mm (23-5/8")
Figure 8
8
3
(G) x 4
A
(G) x 4
3
(A)
CAUTION:
Failure to properly tension cables (C) may
result in damage to ceiling tile framework!
4. Thread each cable (C) completely through cable lock (F),
corresponding hole in corner of ELPMBP04 assembly (A),
and completely through opposite side of cable lock (F) (See
Figure 9). Adjust cable tension until ELPMBP04 assembly
(A) is supported entirely and evenly by all four support
cables, but not so tight as to distort ceiling tile framework.
NOTE:
Cable lock (F) will allow cable to enter from only one
direction per side, indicated by arrows on lock.
Depress spring loaded pins on cable lock (F) to release
cable tension.
C
4
F
Figure 9
Installation Instructions
A
(C, F) x 4