Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Observe all governing codes and ordinances.
Required:
A 120 volt, 60 Hz, AC only, 15- or 20-amp electrical supply
with a fuse or circuit breaker.
Place Cabinet Template
The shadowed area of Template represents the top of the
microwave oven. Make sure it is centered in the space where the
microwave oven will be installed.
A
A. Template
B. Cabinet front edge
1.
Place the Template on the bottom of the cabinet interior as shown
in the illustration above.
2. Tape the template into place.
3. Proceed to "Mark and Drill Holes" section.
Electrical Requirements
INSTALLATION INSTRUCTIONS
B
Recommended:
A time-delay fuse or time-delay circuit breaker.
A separate circuit serving only this microwave oven.
GROUNDING INSTRUCTIONS
For all cord connected appliances:
The microwave oven must be grounded. In the event of
an electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric
current. The microwave oven is equipped with a cord
having a grounding wire with a grounding plug. The plug
must be plugged into an outlet that is properly installed
and grounded.
WARNING: Improper use of the grounding plug can
result in a risk of electric shock. Consult a qualified
electrician or serviceman if the grounding instructions are
not completely understood, or if doubt exists as to whether
the microwave oven is properly grounded.
Do not use an extension cord. If the power supply cord is
too short, have a qualified electrician or serviceman install
an outlet near the microwave oven.
SAVE THESE INSTRUCTIONS
Mark and Drill Holes
1. Mark the four hole centers through the template onto the
lower shelf of the cabinet.
2. Remove the template.
Following are the dimensions for the mounting holes on
Template :
DRILL 3/8" DIAMETER
CABINET CENTER LINE
CABINET FRONT EDGE
3. Using 3/8'' (9 mm) drill bit, f our holes through the centers marked in
Step 1.
4. Place one washer over each of the four drilled holes.
EN-3
4 / "
17
32
13 "
Publicidad
Tabla de contenido
