Stocker Solarjet 0700 Manual De Uso página 8

Ocultar thumbs Ver también para Solarjet 0700:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Introduction
Thank you for purchasing a quality unit. Used carefully and in accordance with the instructions set out below,
your SOLAR GARDEN LIGHT SYSTEM should give you many years of trouble free use. Please read the
instructions carefully to obtain the best results from your purchase.
Your unit features:
Mono-crystal solar panel
2 x solar rechargeable batteries (AA 1,2V 600mAh Ni-Mh)
Safe water resistant
Height 80cm
Location of the SOLAR RAT STOP
1) For the best result, please locate the rat stop in a position
where it can get direct sunlight on the solar panel, and
generally free from cover and shade. (As shown in figure 1).
2) The SOLAR CONTROLLER must be left to charge for 2 sunny days before best results are achieved.
Assembly Instructions
Solar controller installation
1) Carefully remove the UNIT and all the fittings out of the box.
2) Assemble the mounting poles (2), and stakes (3);
3) Push the stake directly into the ground (DO NOT hammer the light or the stakes)
(as shown in figure 2).
4) Slot the controller head (1) on the upper part of the mounting poles carefully.
5) Dig a hole of 15-20cm deep and diameter of 40mm to insert the rat stop
Operation Instructions
The buzzer is set at the bottom of the tube and gives out sound waves from time to time. The sound
lasts for 25-35 s between two waves. When the device is inserted into the earth, it causes earthquake
that can drive away rats. The working range is about 500m², but the effective area will be smaller if
there're any block, so we suggest you install several devices if the distance is more than 30meters.
- Instructions Manual -
1
2
3

Publicidad

Tabla de contenido
loading

Tabla de contenido