Preparing The Machine - Honda FG315 Guía Del Utilizador

Fitting the handlebar
- Remove the lock nut (1) and the
washer (2).
- Fit the handlebar on the shaft from
the chassis as shown in the atta-
ched drawing,
Position the hollowed-out
section of the part (3) towards
the rear.
- Refit the washer (2) and the nut
(1).
- Adjust the handlebar's height and
the offset to suit your wishes befo-
re locking the nut (1).
Fitting the blade
MAINTENANCE
Emptying the fuel
Adjusting the reversing cable
If a malfunction occurs in the reversing system after a few hours of
use, adjust the cable as follows:
1
2 to 3 turns
2

PREPARING THE MACHINE

1
2
3
Hard
ground
Loose soil
ALWAYS STOP THE ENGINE BEFORE ANY MAINTENANCE OPERATION
Air filter
Do not use inflammable solvents
to clean the foam element in the air
filter.
Lock the nut
3
Full of oil
Fitting the tools
4
Repeat this operation
if necessary
7
Full of petrol
SAE 10W40
0,6L
Replacing the belt
Type E2
Type E1
Play
LEAD FREE
2L
Do not use rotary tools
with a diameter greater
than 325mm and a width
greater than 850mm.
E1/E2
275 mm
± 1
333 mm
± 1
Belt
Protective plate