6. Start-up and operation
6.1 Inserting/changing the filter
Warning
• Make sure that the product is disconnected from the mains.
• Since the lter contains all the collected pollutants, it should only
be changed outdoors and with appropriate care against contact
contamination (gloves/respiratory protection).
The lter must be inserted before the rst start-up.
To do this, proceed as follows:
• Pull the front panel upwards away from the air intake openings with both
hands.
• A retaining tab is attached to the top end of the lter for easier
installation. This must point outwards towards the front panel.
• Remove the used lter, if any, and dispose of it in your household waste.
• Remove the new lter from the protective packaging and insert it into the
device. The black side of the activated charcoal lter must face the device.
• Place the lter at the bottom of the lter chamber and insert it using the
retaining tab.
• Replace the front panel and snap it into place.
7. Switching the device on/off
Warning
• Only operate the product from an approved socket that is connected
to the public power supply. The socket must be installed close to the
product and must be easily accessible.
• Disconnect the product from the power supply using the On/Off switch
– if this is not available, unplug the power cord from the socket.
• If using a multi-socket power strip, make sure that the total power
consumption of all connected devices does not exceed the power strip's
maximum throughput rating.
• If you will not be using the product for a prolonged period, disconnect
it from mains power.
• Connect the mains lead on the air puri er to a properly installed socket.
• Switch the air puri er on/off using the ON/OFF button (11).
8. Care and maintenance
Note
Disconnect the device from the mains before cleaning and during
prolonged periods of non-use.
• Only clean this product with a slightly damp, lint-free cloth and do not use
aggressive cleaning agents.
• Ensure that no water is able to enter the product.
* Also see the "Replace Filter" section for detailed cleaning instructions.
9. Warranty disclaimer
Hama GmbH & Co KG assumes no liability and provides no warranty for
damage resulting from improper installation/mounting, improper use of the
product or from failure to observe the operating instructions and/or safety
notes.
4
10. Technical data
Device dimensions:
Power supply:
Power consumption:
CADR value:
Suitable for rooms up to:
Anion concentration:
Filter type:
Weight:
11. Recycling information
Note on environmental protection:
Following the implementation of European Directive 2012/19/EU
and 2006/66/EU into the national legal systems, the following
applies:
Electrical and electronic devices as well as batteries must not
be disposed of with household waste. Consumers are obliged
by law to return electrical and electronic devices as well as batteries to the
designated public collection points or to the point of sale at the end of their
service lives. Detailed information on this topic is de ned in the national laws
of the respective country. This presence of the above symbol on the product,
operating instructions or package indicates that the product is subject to
these regulations. By recycling, reusing the materials or other forms of
utilising old devices/batteries, you are making an important contribution to
protecting our environment.
330 x 200 x 600 mm
220-240 V
55 W
200 m³ / h
17 m² (Ansi/AHAM AC - 1 2015) -
52 m² (NRCC - 54013 - 2011)
< 5 µg/m³ according to IEC
60335-2-65
Pre/coarse lter; EPA 11 lter;
Activated charcoal lter with cold
catalyst layer
5.8 kg