HP LaserJet Pro M203 Guía De Inicio página 3

8. Set up HP ePrint via email (optional)
Use HP ePrint via email to print documents by sending them as an email attachment to the printer's email address from any email enabled device, even from devices that are not on
the same network.
To use HP ePrint via email, the printer must meet these requirements:
• The printer must be connected to a wired or wireless network and have Internet access.
• HP Web Services must be enabled on the printer, and the printer must be registered with HP Connected.
Enable HP Web Services (wireless models only)
1. After the printer is connected to the HP Embedded Web Server (EWS), print
a configuration page and identify the printer IP address.
2. At the computer, open a web browser and enter the printer IP address into the
address line. The HP EWS opens.
3. Click the HP Web Services tab. If the network uses a proxy server do the following:
• Select the Proxy Settings tab.
• Select the Check this box if your network uses a proxy server to access the
Internet check box.
• In the Proxy Server field, enter the proxy server address and port number, and
then click the Apply button.
Troubleshooting
User guide
The user guide includes printer usage and troubleshooting information. It is available
on the printer CD and on the Web:
1. Go to www.hp.com/support/ljM203.
2. Select a printer or category from the list, and then click User Guides.
Check for firmware updates
1. Go to www.hp.com/support/ljM203.
2. Select a printer or category from the list, and then click Drivers.
3. Select the operating system, and then click the Next button.
4. Select Firmware, and then click the Download button.
Resolve error code messages (First Use)
Light Status
Attention light is blinking
Wireless network connection (wireless models only)
• Verify that the printer and wireless router are turned on and have power. Also make sure the wireless switch is turned on.
• Verify that the printer is within the range of the wireless network. For most networks, the printer must be within 30 m (100 ft) of the wireless access
point (wireless router).
• Verify the print driver is installed on the computer.
• Verify that the computer and printer connect to the same wireless network.
• For Mac, verify that the wireless router supports Bonjour.
• Restart the wireless router.
Action
Load the paper into the tray
4. Select the HP Web Services tab, and click the Enable button. The printer
configures the connection to the Internet, and then a message appears indicating
an information sheet will print
5. Click the OK button. An ePrint page prints out. On the ePrint page, look for the
e-mail address that is automatically assigned to the printer.
Additional support resources
For HP's all-inclusive help for the printer, go to
www.hp.com/support/ljM203:
• Solve problems
• Find advanced configuration instructions
• Download software updates
• Join support forums
• Find warranty and regulatory information
• Access mobile printing resources
3