EXPLOSION HAZARD - Substitution of components may impair suitability
for Class I, Division 2.
The Models 27XL and 121XL LED Beacons are explosion-proof visual signaling
devices listed for hazardous and marine locations. The Models 27XL and 121XL are
rated for 24 VDC, and 100 - 265 VAC, 50/60 Hz. The 27XL and 121XL can be supplied
with colors of red, amber, green, blue, and clear. The 27XL and 121XL are factory set to
operate at 60 flashes/minute. There is an option to operate the LED in steady on mode.
Consult the factory for details.
These devices are intended for permanent installation and operation in accordance
with Title 46, Code of Federal Regulations, Parts 110-113, or Title 33, Code of Federal
Regulations, Part 183, Sub-part I, Section 183.410, and the applicable requirements of
the American Boat and Yacht Council, Inc., and/or ANSI/NFPA 302, "Fire Protection
Standard for Pleasure and Commercial Motor Craft."
II.
UNPACKING.
Damaged globes can lead to explosions that could result in serious injury or
death.
After unpacking the Model 27XL or Model 121XL, examine it for damage that may
have occurred in transit. If the equipment has been damaged, do not attempt to install
or operate the unit. File a claim immediately with the carrier, stating the extent of the
damage. Carefully check all envelopes, shipping labels and tags before removing or
discarding them. Disposal of all shipping materials must be carried out in accordance
with national and local codes and standards.
III.
INSTALLATION.
To prevent ignition of Hazardous Atmospheres, disconnect the fixture from
the supply circuit before opening. Keep tightly closed when in operation.
Not to be used as a Visual Public Mode Alarm Notification Appliance.
Mounting Position Limitation: "For Vertical Mounting, Globe Down, Only".
This device is "factory sealed". Failure to maintain the seal will compromise the
environmental ratings for the product.
The fixture mount has provisions for mounting a 3/4" pipe.
NOTE
-2-