Yokis MTV300MRP Manual Del Usuario página 9

MTV300MRP – Cod. 5454479
Modular Timed power wireless dimmer
Functions
This module is used to vary the brightness of a light with radio control.
Technical specifications
Mains voltage:
Minimum power:
Maximum power:
Radio frequency:
Ambient temperature:
Relative humidity:
Dimming:
Protections:
Dimensions:
Standard connection scheme
Test Button
State light
Connection
button
BP
BP
DS1054-053A
230 V ~ (+10% -15%) - 50Hz
5 W
300 W 1.3 A
2,4 GHz
from -20°C to +40°C
from 0 to 70%
on sinusoidal at start or end of phase
with automatic load type detection
short-circuit and overheating
protections
90 x 17.5 x 60 mm
In order to follow the safety rules, the module must be connected to a
power line that is upstream protected by a magnetothermic switch 10A C
curve used as overload protection and circuit breaker device.
Important: The product does not have consolidated insulation between
the "Connect" button, the test button, the LED and the circuit powered by
the network; use appropriate insulating tools to access these buttons.
The equipment must be installed and in a place inaccessible to the end
1 2 3
user, inside a box / electrical panel with key.
Wiring
Installation on remote controlled sockets is risky because end users
could connect any type of electrical load and damage the module as
CAUTION
Accessory FDVDT (Code 5454075) must be installed if the power line
of the module is shared with inductive loads (e.g. window shutters or
ferromagnetic ballasts or ferromagnetic transformers).
4 5 6
The accessory must be connected as close as possible to the module in
parallel between live and neutral. The internal overvoltage protection of the
module could be rapidly damaged without this accessory. The module
must be installed according to the rules in force in the country in which it is
sold.
The brightness must be set to a higher level if the light flickers when it is
dimmed. Accessory CHR3W may be connected in parallel between light
bulb return and neutral to suppress or attenuate flickering.
WARNING: Check that the light comes on at the minimum brightness level.
Otherwise, increase the minimum brightness level.
RADIO RANGE:
POWER range:
• inside 100 m² apartments with perpendicular crossing
of main wall or ceiling
• 250m in open range
(Note: in both cases the range may be reduced by pre-
sence of metallic elements, crossing of walls or parti-
tions).
RADIO TRANSMISSION
The transmitter LED will light up only if radio
transmission was successful.
Adding an intermediate receiver makes it possible to
solve a problem of insufficient range.
Refer to the transmitter instruction booklet for more infor-
mation.
Recommendations / Installing Cautions
DO NOT INSTALL ON REMOTE CONTROLLED SOCKETS
a consequence.
Use with energy-saving or LED light
P9
GB