Porter Cable PCE1700 Manual De Instrucciones página 18

PROBLEM
Wand not in low pressure.
Will not draw
chemicals
Chemical filter clogged.
Chemical screen not in chem i cal
Chemical too thick.
Pressure hose is too long
Chemical build up in chemical
injector.
Worn seal or packing
No or low
pressure
Worn or obstructed valves.
(after period
Worn unloader piston.
of normal
use)
Worn E-Z start valve.
Water
Worn or broken o-ring.
leaking at
gun/wand
Loose hose connection.
connection
Loose connections.
Water
leaking at
Piston packings worn.
pump
Worn or broken o-rings.
Pump head or tubes damaged
from freezing.
Recommended accessories for use with your pressure washer are available
for purchase from your local retailer or authorized service center. If you need
assistance in locating any accessory for your tool, please call call 1-888-848-5175
or visit our website www.porter-cable.com.
rated equal to or greater than the rating of the pressure washer.
To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment should be performed by an Authorized Warranty Service Center.
Always use identical replacement parts. For the location of the nearest
Authorized Warranty Service Center call 1-888-848-5175 or visit our website
www.porter-cable.com.
A17914
CAUSE
ACCESSORIES
The use of any other accessory not recommended for use
with this tool could be hazardous. Use only accessories
REPAIRS
See How to Use Wand paragraph
in the Operation Section.
Clean filter.
Insure end of chemical hose is
fully submerged into chem i cal.
Dilute chemical. Chemical should
be the same consistency as
water.
Lengthen water supply hose
instead of pressure hose.
Have parts cleaned or replaced
by AWSC.
Have replaced by AWSC.
Have replaced by AWSC.
Have replaced by AWSC.
Have replaced by AWSC.
Check and replace.
Tighten.
Tighten.
Have replaced by AWSC.
Have replaced by AWSC.
Have replaced by AWSC.
18- ENG
CORRECTION