Connections To Be Made - Axxess LC-GMRC-01 Instrucciones De Instalación

Connections to be made

From the LC-GMRC-01 harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Red wire to the accessory wire.
• Connect the Blue/White wire to the power antenna wire.
• If the aftermarket radio has an illumination wire, connect the Orange
wire to it.
Note: There are (2) Orange wires. If the Orange wire on the 24-pin
harness is populated on the factory side, use that wire. Otherwise,
use the other Orange wire.
• Tape off and disregard the Orange/White wire, it will not be used in
this application.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative speaker output.
LC-GMRC-01
Connections to be made
The following (3) wires are only for multimedia/navigation radios that require these wires.
• Connect the Blue/Pink wire to the VSS/speed sense wire.
• Connect the Green/Purple wire to the reverse wire.
• Connect the Light Green wire to the parking brake wire.
Installing the LC-GMRC-01
With the key in the off position:
• Connect the LC-GMRC-01 harness into the interface.
• Connect the LC-GMRC-01 harness to the vehicle.
Initializing the LC-GMRC-01
Attention: If the interface loses power for any reason, the following steps
will need to be performed again.
• Turn the key (or push-to-start button) to the ignition position and wait
until the radio comes on.
Note: If the radio does not come on within 60 seconds, turn the key
to the off position, disconnect the interface, check all connections,
reconnect the interface, and then try again.
•
Turn the key to the off position, and then to the accessory position. Test all
functions of the installation for proper operation, before reassembling the dash
3
.