Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Replacing the Heating Element
Only perform this operation when the element is cold and the unit is disconnected from the mains.
1. Loosen the screw.
2. Pull the heating element away from the handle.
3. Connect the new heating element, ensuring its pushed all the way in.
4. Tighten the screw.
Heating Element
Ref. 0014107 (230V)
0014105 (100V / 120V)
Handle
Ref. 0009829
Changing the JT-TA Heater Hose Set
1. Ensure that the tool is turned off.
2. Use a spanner to unscrew the connecting nut.
3. The tube end of the new heater must be inserted
so that the longitudinal rib fits into the groove.
5. Follow the same steps conversely.
10
10
Heating Hose Set
Ref. JT-T1A (100V / 120V)
JT-T2A (230V)
Pick & Place
(not supplied with JT)
This tool helps you easily place and remove SMDs of any size thanks to the suction pump.
Pick & Place
Bent Needles Set
Ref. T260-A
Ref. 0861660
Operation
Choose the needle and the suction cup that best fits the component and start working as follows:
Press the button to
start/stop the suction
Pick & Place
Ref. T260-A
Maximum working temp: 250ºC (482ºF)
Insert the needle
You should
with the appropriate
avoid the needle
cup for a correct
protruding from the
suction process.
lower part.
w w w.jbctools.com
Straight Needles Set
Ref. 0901546
1. Suction
2. Release
Once the suction is
Lift your finger
activated, cover the
to release the
pen hole with your
component in the
finger and lift off the
appropriate place.
component.
11
11
Publicidad
Tabla de contenido
