Proposition 65; Installation; Unpack The Machine; Add Bar And Chain Oil - GreenWorks Pro 2015502CT Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

EN
7

PROPOSITION 65

This product contains a chemical known to the state of
California to cause cancer, birth defects or other
reproductive harm. Some dust created by power sanding,
sawing, grinding, drilling, and other construction activities
contains chemicals known to cause cancer, birth defects or
other reproductive harm. Some examples of these chemicals
are:
Lead from lead-based paints;
Crystalline silica from bricks and cement and other
masonry products;
Arsenic and chromium from chemically treated lumber.
Your risk of exposure to these chemicals varies depending
on how often you do this type of work. To reduce your
exposure to these chemicals, work in a well-ventilated area,
and work with approved safety equipment, such as dust
masks that are specially designed to filter out microscopic
particles.
Save these instructions.
8

INSTALLATION

Do not change or make accessories that are not
recommended by the manufacturer.
Do not install battery pack until you assemble all the parts.
8.1

UNPACK THE MACHINE

Make sure that you correctly assemble the machine before
use.
If parts of the machine are damaged, do not use the
machine.
If you do not have all the parts, do not operate the
machine.
If parts are damaged or missing, contact the service
center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance with
local regulations.
WARNING
WARNING
WARNING
WARNING
WARNING
English
8.2

ADD BAR AND CHAIN OIL

Examine the amount of oil in the machine. If the oil level is
low, add the bar and chain oil as follows.
Use only bar and chain oil.
The machine comes from the factory without bar and chain
oil.
1. Loosen and remove the cap (6) from the oil tank.
6
7
2. Put the oil into the oil tank.
3. Monitor the oil window (7) to make sure that no dirt gets
into the oil tank while you add the oil.
4. Put the oil cap on.
5. Tighten the oil cap.
6. The whole oil tank will last for approximately 20- 40
minutes.
Do not use dirty, used or contaminated oil. Damage can
occur to the bar or chain.
8.3

INSTALL THE BATTERY PACK

If the battery pack or charger is damaged, replace the
battery pack or the charger.
Stop the machine and wait until the motor stops before
you install or remove the battery pack.
Read and understand the instructions in the battery and
charger manual.
8

IMPORTANT

NOTE
IMPORTANT
WARNING

Publicidad

Tabla de contenido
loading

Tabla de contenido