Install Ductwork - Bosch DHD865AUC Instrucciones

INSTALL DUCTWORK

CAUTION - BEFORE CUTTING HOLE IN CABINET FOR DUCT-
WORK: Check for interference with floor joists, wall studs, electri-
cal wiring or plumbing.
ç BLOWER
SCREWS
1. Cut hole in cabinet as well as holes in wall or floor as
necessary.
2. Mount the roof or wall cap and work back towards the cabinet,
attaching all ductwork, elbows and transitions as previously
planned. Tape all ductwork connections to make them secure
and air tight.
3. Connect ductwork (and transition, if required) to downdraft. If
necessary, LOOSEN nuts and screws that hold the blower in
place, and slide blower left or right to meet ductwork. Re-
tighten screws and nuts.
Note: A 3-1/4" x 10" collar is provided for installers who prefer to
rivet the ductwork to the unit. This will allow blower to be removed
and replaced easily in service situations without disturbing
ductwork.
INSTALL ELECTRICAL WIRING
1. Mount a standard wiring box, with 3-pronged receptacle,
inside the cabinet. Make sure the downdraft's power cord can
easily reach it.
2. Run appropriate power cable into cabinet and connect it to
receptacle.
3. Plug the downdraft's power cord into the outlet.
INSTALL COOKTOP
1. Align the cooktop with the downdraft and fasten cooktop in
place.
Note: Accurate alignment of cooktop and downdraft is necessary
to ensure that there is no interference when air vent is raised and
lowered. There should be a gap of 1/32"-1/16" between the back
of the cooktop and the front of the downdraft cover.
è
3-1/4" X 10"
TO 6" RD.
TRANSITION
COLLAR
6" RD.
ELBOW &
DUCT-
WORK
OPERATION
UP / DOWN --- Raises and lowers vent.
Turns blower ON when vent is UP and OFF when
vent is DOWN.
DELAY --------- Allows blower to run for 5 min. after button is
pressed. Blower will run for 5 min. - then shut
OFF. VENT WILL NOT LOWER. You must press
UP / DOWN to lower vent.
LOW / MED / HIGH ----- Operates blower at 3 different speed
levels. Press button ONCE to turn blower
ON to desired speed. Press button
AGAIN to turn blower OFF.
FILTER LIGHT ----------- Comes ON after 30 hours of operation
to remind you to clean filters. Press
button to reset.
OPTIONAL DOOR KITS
MODEL NO.
DHZ8020
DHZ8060
DHZ9020
DHZ9060
USE AND CARE
CLEANING
WARNING: Always disconnect electric
power supply before cleaning unit.
Use a mild detergent suitable for painted surfaces. DO NOT USE
ABRASIVE CLOTH, STEEL WOOL PADS, OR SCOURING
POWDERS. Vacuum blower to clean. Do not immerse blower in
water.
Wash the 2 aluminum/stainless steel grease filters in a mild
detergent solution or a dishwasher. Remove them from the air
vent by grasping the tab at the top of each filter.
SERVICING
WARNING: Always disconnect electric
power supply before servicing unit.
It may be necessary to remove the downdraft blower system from
the cabinet in order to service components such as the blower
motor or air vent mechanism.
Disconnect power to the cooktop and remove it first. Reverse the
steps under "MOUNT THE UNIT" to remove the downdraft from
the cabinet.
4
DESCRIPTION
30" White
30" Black
36" White
36"Black