Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Tools and Parts
Tools Needed
Gather the required tools and parts before starting
installation.
Read and follow the instructions provided with any tools listed
here.
#2 Phillips
screwdriver
Drill with 7⁄64" bit
Tape measure
or #35
Parts Supplied (not shown to scale)
Trim Frame
Phillips Round-Head Screws
24 (21 or 22 required for
installation)
Anti-Tip Bracket
Bottom Bracket
INSTALLATION INSTRUCTIONS
Pencil
Awl or punch
Scissors (optional)
Bottom Duct
Top Bracket
Phillips Flat-Head Screws
5 (4 required for installation)
Template
Location Requirements
The microwave oven may be installed over a built-in wall
oven. Make sure there is a minimum of 3'' (7.6cm) between
the top of the lower oven cutout and the microwave oven
cutout floor. See Fig. 1 below
The microwave oven may also be installed in a cabinet by
itself(without a built-in oven below). For best usability access,
there should be a minimum of 36'' (91.4) from the floor to the
microwave oven cutout floor. Allow a clearance of at least
1-9/16''(4.0cm) below the microwave oven cutout. See Fig.2
below.
In each case, there must be a minimum of 2''(5.1cm) between
the cutout opening and a cabinet or surface above. See both
figures below.
Fig. 1
A
B
C
A. Upper cabinet
B. Microwave oven cutout
C. Lower oven cutout
EN-2
Fig. 2
2"
2"
(5.1 cm)
(5.1 cm)
B
1
9/16
"
3"
(4.0 cm)
(7.6 cm)
D
E
D. Lower cabinets
E. Floor
A
36"
(91.4 cm)
Publicidad
Tabla de contenido
