Skil LT4818-00 Manual Del Propietário página 21

Remove the Trimmer Head
1. Remove the battery pack from the trimmer.
2. Press the release tabs on the trimmer head and remove the lower cover of the trimmer
head by pulling it straight out.
3. Remove the cutting line from the trimmer head (Fig. 22).
4. Take the spring out of the lower cover, if necessary. Save it for reassembly.
5. Wear gloves. Use one hand to grasp the spool assembly to stabilize it, and use the other
hand to hold an impact wrench to loosen the nut in the counterclockwise direction
(Fig. 23).
6. Remove the nut, spool assembly, upper cover, and shroud from the motor shaft.
7. Replace with a new trimmer head and mount it as follows.
Fig. 22
Install the New Trimmer Head
1. Align the key slot in the shroud assembly with the spline in the motor shaft and mount the
shroud assembly into place.
2. Mount the upper cover, spool assembly, and washer in that order. Use an impact wrench
on the nut to tighten it.
3. Following steps 4 & 5 in "Reload the Cutting Line" section in this manual to mount the
lower cover assembly.
4. Follow the instructions in "Line Replacement" section in this manual to reload the cutting
line.
5. Start the tool to see whether the string trimmer will work normally. If it does not,
reassemble as described above.
Clean the Trimmer
Clear any grass that may have wrapped itself around the motor shaft or trimmer head.
•
Use a small brush or a small vacuum cleaner to clean the air vents.
•
Keep the air vents free of obstructions.
•
Clean the unit using a damp cloth with a mild detergent.
•
Do not use any strong detergents on the plastic housing or the handle. They can be
•
damaged by certain aromatic oils, such as pine and lemon, and by solvents such as
kerosene. Moisture can also cause a shock hazard. Wipe off any moisture with a soft, dry
cloth.
Fig. 23
Impact
Wrench
21