Lumex 7108R Instrucciones De Montaje Y Operación página 2

SETUP (REFER TO PICTURE BELOW)
Height Adjustment
Height Adjustment
s NOTICE: DO NOT use excessive force when installing the seat and lid.
1. Remove frame, seat, lid, pail, cover, and splash guard from carton.
2. Attach front support bar to armrest by depressing the locking button and sliding into
the front support bar channel guide until it clicks into place. Repeat for other side.
Ensure the locking buttons protrude fully from the holes.
3. Attach seat to rear support bar. Push down firmly until the seat snaps into place.
WARNING: When installing the seat on the frame, ensure the seat is
evenly spaced between the side frames to ensure proper stability.
4. Attach lid to rear support bar.
5. In the upright position, place splash shield or pail and cover in frame.
Adjusting Commode Height
1. Depress the height adjustment button and slide the lower leg upward or downward
until the height adjustment button clicks into place in the desired hole.
2. Repeat for other 3 legs.
WARNING: Ensure that all four commode legs are adjusted to the same
height, and that all height adjustment buttons protrude fully through
adjustment holes before use.
7108R-INS-LAB-RevB13
Lid
Seat
Armrest
Frame
Holes
Button
Pail Support
Lower Leg
Tip
7108R Folding Steel Commode
Back Support
Back Support
Channel Guide
Rear
Support Bar
Front
Support Bar
Front Support Bar
Channel Guide
Pail
2