Kenmore 68102 Manual De Uso página 39

4, Select the desired cycle
AUTO DRY
Bulky Normal
Casual
TIMED
CYCLES --
Timed Dry 'Delicates
Touch L
Dry
Select the desired cycle for your load. See the _'Cycle Guide"
for more information about each cycle.
NOTE: Not all cycles are available on all models.
5. Adjust cycle modifiers, if desired
@ High
_, Med High
@ Medium
@ More
@ Low @ Normal
Air Only @ Less
TIMED CYCLES ONLY AUTO CYCLES ONLY
You may adjust different settings, depending on whether you
have selected an Auto Dry Cycle or Timed Cycle. See the _'Cycle
Guide" for detailed information.
NOTE: Not all options and settings are available with all cycles.
Auto Dry Cycles:
You can select a different Dry Level, depending on your load,
by pressing the Dry Level button. Selecting More, Normal, or
Less automatically adjusts the Dry Level at which the dryer will
shut off. Once the Dry Level is set, it cannot be changed without
stopping the cycle.
Sensor cycles give the best drying in the shortest time. Drying
time varies based on fabric type, load size, and dryness setting.
Timed Cycles:
When you select a Timed Cycle, the default
time appears in the display. Use the Time
Adjust buttons to increase or decrease the
time in I minute increments. Press and hold
to change the time in 5 minute increments.
The default temperature may be changed by
pressing the Dry Temp button until the desired
drying temperature lights up.
_STI_TED TIM_
More Time
TIMED
CYCLES
LessTime
Select any additional options
AUTO CYCLES ONLY
Add additional options such as Wrinkle Guard
TM
150 or Damp
Signal by pressing the button for that option.
Wrinkle Guard
TM
150:
Promptly remove garments after cycle has completed to
reduce wrinkling. Use the Wrinkle Guard
TM
150 feature to
avoid wrinkling when you are unable to remove a load from
the dryer as soon as it stops.
7. Press START/PAUSE to begin cycle
®
START/PAUSE
Press the START/PAUSE button to begin the cycle.
FChanging the Auto Dry Cycle Settings
to Increase Drying Time
If all your loads on all Auto Dry cycles are consistently not
as dry as you would like or are too dry, you may change the
default settings to increase or decrease the default Dryness
Level.
The sensor drying settings on Auto Dry cycles can be
adjusted to adapt to different installations, environmental
conditions or personal preference. This change is retained
and will affect all of your Auto Dry cycles_ not just the
current cycle/load.
There are 5 drying settings_ they will appear in the time
display:
01 Factory preset dryness level.
02 Slightly drier clothes, 15% more drying time.
03 Much drier clothes, 30% more drying time.
04 Much damper clothes, 30% less drying time.
05 Slightly damper clothes, 15% less drying time.
To change the drying settings:
NOTE: The settings cannot be changed while the dryer
is running or paused. The dryer must be in standby mode
(the Power button is off) to adjust the default settings.
1. Before starting a cycle, press and hold the DRY LEVEL
button for 6 seconds.
2. Press the DRY LEVEL button to select the dryness level
shown in the time display: 01, 02, 03, 04, or 05.
3. Press START/PAUSE to save the new DRY LEVEL setting.