Scope Of Delivery; Assembly - Apollo Genius PRO 4.0 Manual Del Usuario

- Only to be used by persons who have sufficient skills and knowledge to prevent injury or damage from accidents. Hold the handlebars
with both hands when riding.
- Sensitive surfaces may be damaged by the scooter, please take appropriate protective measures.
- Use by children only under adult supervision.
- Screws and other small parts can be swallowed and thus lead to suffocation. Installation only to be carried out by an adult.
- Keep the packaging material away from children. Risk of suffocation!
- Check the scooter for perfect condition before each use. Defective parts must be replaced immediately - defective parts can cause
considerable danger to the user.
- Protect the scooter from moisture, high temperatures and direct sunlight.
- Check the ball bearings regularly. The biggest enemy of ball bearings is dirt and dust. Lubricate with light oil or special ball bearing
lubricant. Use on cleaned ball bearings extends their life. Please note: Lubricants with a more pasty consistency may attract dirt and
shorten the life of the ball bearings.
Replace seized ball bearings immediately.

3. Scope of delivery

1x Stunt Scooter
2x tool

4. Assembly

- The stunt scooter must be carefully assembled by an adult person. If necessary, seek the help of a technically experienced person.
- Read the assembly instructions carefully and completely before starting the assembly.
- Remove all parts from the packaging, remove protective films and place all parts on a free surface.
Protect the mounting surface with a base.
- Check the delivery for completeness before disposing of the packaging.
- Do not leave any packaging material or tools lying around. Risk of injury!
- After assembly, the seat of all screws and bolts, even pre-assembled ones, must be checked.
Step 1: Insert the handlebar rod into the handlebar clamp.
Step 2: Push the handlebar rod and handlebar clamp onto the front axle of the stunt scooter.
Step 3: Align the front wheel in the direction of travel and place the handlebars at right angles to the direction of travel.
Secure this connection by tightening the screws on the handlebar clamp with the Allen wrench.
Step 1:
Step 2:
Step 3: