HSM TA 3200 Manual De Instrucciones página 2

Operating instructions
HSM TA 3200 Rotary Trimmer
Specifi cation
The rotary trimmer is designed for the creative cutting
of paper, fi lm and other soft materials up to a maximum
cutting height of 0.6 mm.
Cutting unsuitable material or exceeding the
cutting height can cause damage.
1 Cutting table
2 Clamp
3 Cutting head holder
4 Cover
5 Enclosed cutting blade
Selecting the cutting head
The rotary trimmer is supplied with cutting heads for
three different types of cutting:
• Straight cutting
• Wavy cutting
• Perforated cutting
You can easily exchange the cutting heads:
- Open the cover of the cutting head holder and push the
cutting head upwards.
- Select a cutting head from the storage compartment
and place it in the cutting head holder. Close the cover.
HSM Pressen GmbH + Co. KG ● Bahnhofstraße 115 ● D-88682 Salem
Telephone +49 (0) 75 53 / 822-0 ● Fax +49 (0) 75 53 822 160 ● www.hsm-online.de
TA 3200
6 Spare cutting blades
7 Storage compartment
8 Cutting rail
Cutting
Pull the clamp up and posi-
tion the material to be cut.
Observe the scale on the
cutting table.
Close the clamp until it
latches into place again.
The cutting material is now
fi rmly in place.
Press down on the
cover of the cutting
holder and guide the
cutting head slowly
and evenly along the
glide rail.
Replacing the cutting rail
If the cutting rail has
been damaged due to
long periods of use,
you can fi rst turn it over
and use the other side.
Make sure that the dot-
ted line of the cutting
marking is right under
the cutting blade again
and the scale of the
cutting table matches the cutting rail.
If the cutting rail can no longer be used,
replace it with a new one.
Max. paper size
Cutting length
Cutting height
Cutting capacity (70 g/m 2
Cutting types
Scope of supply
Size (W x D x H)
Weight
english
1 1 1 1
2 2 2 2
cm cm
2 1 0
1
inch inch
DIN A4
310 mm
0.6 mm
) 6 sheets
in all 3 cutting types
Straight
Wavy
Perforated
2 spare cutting rails
each with 2 sets of spare
blades
80 x 205 x 380 mm
0.6 kg
0