NuTone LA-203RWH Manual Del Usuario

READ & SAVE THESE INSTRUCTIONS!
Plug-in
Door Chime Receiver
MODEL:
LA-203RWH
For use with these NuTone wireless products:
LA-203WH, LA-205WH, LA-206WH, LA-206TWH,
LA-207TWH (sold separately)
NuTone
To install:
1. Simply plug chime receiver into any standard electrical
wall outlet within 100 feet of Pushbutton.
(Chime is powered by household current.)
2. Chime will sound when Pushbutton is pressed.
NOTE: Chime Receiver will not work alone.
TO REGISTER THIS PRODUCT, VISIT WWW.NUTONE.COM
If you should encounter a problem.
INSTALLATION &
OPERATING INSTRUCTIONS
PROBLEM
1. Chime does not sound.
2. Chime is activated by
another wireless device.
CHANGING THE SECURITY CODE
ON CHIME RECEIVER
To use the LA-203RWH Chime Receiver with your NuTone
Wireless Chime, set code in this Chime Receiver to match
code set in your Pushbutton. Here's how:
1. Remove cover of Pushbutton by inserting screwdriver in
the slot at the bottom of the Pushbutton and then gently
rock the Pushbutton cover apart from the base. (Figure 1)
Locate vertical row of black jumpers on right side of
Pushbutton. (Figure 3 Detail)
2. Remove the screw from the access cover on back of
Chime Receiver, then remove cover. (Figure 2)
3. Set the code switches in the Chime Receiver to match the
black jumpers in the Pushbutton. If a black jumper is in
place, then the corresponding switch on the Chime
Receiver must be set in the "ON" position. (Figure 3)
For example: if jumper #1 is in place, code switch
#1 should be in the ON position.
4. After setting the switches, replace the cover and screw on
back of Chime Receiver.
5. Replace Pushbutton cover.
SLOT
TO OPEN
COVER
"PUSH"
SOLUTION
• Check position of battery (+/–) in
Pushbutton.
• Make sure Pushbutton is not located on a
metal surface.
• Check that outlet on Chime Receiver has
power.
• Check Pushbutton and Chime codes.
These codes must match.
• Change the security code
in the Pushbutton and Chime Receiver.
These codes must match.
(See detailed instructions below.)
REMOVE SCREW
AND COVER FROM
BACK OF CHIME
RECEIVER
FIGURE 2
FIGURE 1
CHIME RECEIVER
TOP
SECURITY
P.C.
CODE
BOARD
SETTING
BATTERY
LOCATION
SET 1, 3 & 6
SWITCHES
TO "ON"
EXAMPLE: CHANGING CODE SETTING
Product specifications subject to change without notice.
4820 Red Bank Road, Cincinnati, Ohio 45227
Printed in China, Rev. 4/07 Part No. 88299
PLUG-IN
FIGURE 3