Assembly - IRIS Woozoo TWF-C101 Serie Instrucciones De Uso

Wet hands prohibited.
• Do not unplug power plug when hands are wet.
Do not use the product outdoors.
• Do not use in the vicinity of objects that obstruct the flow of air.
• Do not operate while covered or blocked with cloth, paper, or plastic bags, etc.
• Do not use in locations where there is a lot of dirt or dust. This can cause short-circuit or fire.
• Do not use in or near environments filled with sooty air. Doing so may cause a fire.
• Do not use in rooms with high humidity levels such as bathrooms.
• Do not get the unit wet, or put the unit in water. Getting the product wet can cause fire or electric shock.
If handled incorrectly, contents can lead to personal injury or physical damage.
• Keep out of reach of children and infants.
• Do not climb on or tip the product over. Doing so may lead to injury or electric shock.
• Make sure to hold the handle while moving product. Do not drag the product when moving it. Dragging
product can damage carpet and floors.
• Do not point air flow directly at your body. It generates a very strong air flow.
• Be especially mindful not to allow children or elderly people near product. Being near the product can be
harmful to their physical condition and to their health.
• Air blowing directly on plants may be harmful.
• Do not strike the unit forcefully. Doing so can cause the product to malfunction, leading to fire or electric
shock.
User Servicing Instructions
• If the fuse on your fan has blown, grasp the plug and remove it from the outlet. Do not pull the cord to unplug.
• To open, slide the fuse cover towards the prongs of the plug.
• Carefully remove the old fuse and snap the replacement fuse into place. To reduce the risk of fire, only
replace the fuse with another fuse of the proper rating (2.5Amp, 120Volt). Slide the fuse door back into place
to close. Discard the blown fuse. The plug should now be ready for normal use.
• Risk of fire. Do not replace the attachment plug. Product contains a safety device (fuse) that should not be
removed. Discard the product if the attachment plug is damaged.
• If you need further information on how or when to replace the fuse in plug, please contact IRIS USA, Inc.
customer service at 1-800-320-4747.
3

ASSEMBLY

The tower fan comes disassembled. Please follow the instructions for proper assembly. The packaging materials
can be used for storing the product when not in use.
CAUTION
Do not plug the power plug in or operated the product before the product has been assembled.
1 Remove the screws from the main body.
• Lay the main body flat and remove the screws attached to the
bottom of the product.
2 Install the base.
• Pull the cord through the center hole of the base.
• Fit the tabs of the back base through the holes of the front base
until the claws on the back base click firmly into place with the
front base.
3 Attach the base to the main body.
• Align the screw holes of the assembled base with the screw holes
on the bottom of the main body. Fasten the base to the body with
the previously removed screws.
• The front of the base should align with the front of the main body,
otherwise the product cannot be assembled.
• The product cannot be assembled on the ground. Please assemble
the product with the main body elevated to allow room for the
base to be installed.
CAUTION
Please make sure that the power cord is not smashed between the base and the main body.
4 Pull the power cord through the cord control tab.
• After assembly, place the product upright to confirm that the base
is firmly attached.
Base (front)
Tabs
Claw
Base (back) Pull the power
cord through
Power cord control
Power cord
4
Hole