Datamars Unigizer 15 J Guía De Instalación Y Uso página 6

To remove the battery leads:
1 Remove the clips from the battery terminals.
2 Hold the battery lead by the rubber sleeve at the end of
the wire. Pull firmly to remove the connector from the
Power input socket on the rear of the energizer.
Installing the energizer indoors
The energizer must be installed indoors, (under cover) when
being powered by mains/line power.
WARNING!
- Do not use a mains/line power extension lead.
- Allow 25 mm (1") of clear space around the power
adaptor.
To install the energizer indoors:
1 Select a suitable installation site. See
the installation
on page 5.
2 Mount the energizer on a wall 1.7 m (5'6") above
ground level. Use the template printed on the back cover
of this manual, if required.
3 Connect the Fence earth terminal (green) to the
energizer earth system.
4 If earth monitoring is desired, connect the Fence earth
monitor terminal (black) to a separate earth rod. For
more information, see
5 Connect the Fence high energy terminal (red) or the
Fence low energy terminal (yellow) to the main farm
fence.
6 If a lower energy output is required on a separate fence
(e.g. house fence, fence adjoining roadside), connect the
Fence low energy terminal (yellow) to this fence.
7 Connect the energizer to mains/line power using the
mains/line power adaptor provided. See
adaptor and battery leads
Note:
For information about using the Fence low energy
Lowering the energy output
terminal see
6
Selecting a site for
Earth monitoring
on page 9.
Using the power
on page 5.
on page 13.
Note:
If the energizer is being installed indoors, it may be
powered by a battery instead of mains/line power, if
required.
WARNING!
If using a battery to power an energizer that
is installed indoors, ensure that there is adequate
ventilation to allow battery gases to disperse.
Installing the energizer outdoors
The energizer may be installed outdoors, powered by a
battery.
WARNING!
Do not power the energizer with mains/line
power if it is being installed outdoors.
To install the energizer outdoors:
1 Select a suitable installation site. See
the installation
on page 5.
2 Mount the energizer on a post. Use the template printed
on the back cover of this manual, if required.
3 Connect the Fence earth terminal (green) to the
energizer earth system.
4 If earth monitoring is desired, connect the Fence earth
monitor terminal (black) to a separate earth rod. For
more information, see
5 Connect the Fence high energy terminal (red) or the
Fence low energy terminal (yellow) to the main farm
fence.
6 If a lower energy output is required on a separate fence
(e.g. house fence, fence adjoining roadside), connect the
Fence low energy terminal (yellow) to this fence.
7 Connect the energizer to the battery using the battery
Using the power adaptor and
leads provided. See
battery leads
on page 5.
Note:
For information about using the Fence low energy
Lowering the energy output
terminal, see
Selecting a site for
Earth monitoring
on page 9.
on page 13.