Kalorik WFVC 44452 Instrucciones De Uso página 19

Aspirador con filtro de agua
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Vacuum cleaner
is
over heating
Vacuum cleaner
is depositing dirt
on the floor after
it is stopped
The air coming
out of
the vacuum
cleaner
smells
www.KALORIK.com
2.
Water in the
reservoir is very
dirty
3.
Filter is dirty
Filter is dirty
1. The vacuum is not
completely charged,
reducing suction
2. The floor brush is
obstructed and is not
able to rotate freely
3. The size of the
particles being picked
up may be too large
4. Other reasons
1.
Filter is dirty
2.
Filter is not dry
so, clear the blockages
before using.
2.
Change the water in
the reservoir to fresh
water.
3.
Clean the filter. It is
recommended to
replace the filter one
time per year to
maintain maximum
performance.
Check the filter and clean
off any dirt.
1. Completely charge the
vacuum before use,
2. Clean the floor brush
before use to maximize its
efficiency. For use on
carpets, make sure to use
the 'Power' setting rather
than 'Eco' speed setting.
3. Make use of the 'Power'
setting rather than the 'Eco'
setting to increase suction.
4. When vacuuming is
complete, let the vacuum
run over a clean section for
10 seconds to allow all the
dirt to be completely pulled
up from the brush and the
hose into the water
reservoir.
1.
Check the filter and
clean off any dirt.
2.
Make sure the filter has
been left to dry
completely before
inserting it back into the
handheld unit.
19
WFVC 44452 - 180330

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido