Charging The Battery - MADER KWIW1802-20 Manual De Instrucciones

WARNING! This machine produces an electromagnetic field during operation.
This field may under some circumstances interfere with active or passive
medical implants. To reduce the risk of serious or fatal injury, we
recommend persons with medical implants to consult their physician and
the medical implant manufacturer before operating this machine.
8. OPERATION
8.1 C
HARGING THE BATTERY
The battery (5) must be charged before first use. Only after several charge and
discharge cycles the battery will attain full capacity.
Only use the provided adaptor (10) to charge the battery set.
Only charge the battery set when the ambient temperature is within 10° - 40 °C.
Plug the adaptor (10) to a 230 V alternating voltage source.
The battery (5) should under no circumstances be disassembled.
To remove the battery, press the battery release button (6) on the top side of the
battery set and extract the battery (5).
Connect the plug of the charger to the loading-socket (9) of the battery-set.
Red LED will light once the battery has been connected to the charger and the
charging procedure will proceed.
The battery set is completely loaded and ready for use once the green LED is lit and
the red LED is OFF – after approximately 3-5 hours.
Defective or used battery sets must be disposed of in specialized refuse and
must not be placed in domestic refuse.
8.2 P
OSITIONING AND REMOVING A DRILL OR SCREW BIT
This tool is equipped with a keyless chuck.
• Open the chuck by turning the collar.
• Insert the drill or screw bit in the chuck.
• Close the chuck by firmly tightening the front collar (a) while holding the rear
part (b) of the chuck with the other hand.
• In order to remove the drill or screw bit proceed in reverse order. Before
positioning or removing a drill or screw bit always remove the battery from
the machine.