fourstargroup 11222461 Manual De Usuario

CAUTION :
1. PLEASE READ ASSEMBLY INSTRUCTIONS BEFORE
ASSEMBLING.
2. IT WILL BE EASIER IF TWO PEOPLE ASSEMBLE THE
LADDER SHELF TOGETHER.
ASSEMBLY TOOL REQUIRED
PHILIPS SCREWDRIVER
Do you have any questions? Missing small parts or hardware? If you need
assistance with the assembly of your LADDER SHELF please e-mail
our Customer Service Department at:
call us at (800) 639-3803 or (508) 435-4830
from Massachusetts area
Please include the following information in your email:
• Where item was purchased • Item, model, style or SKU number listed on
instructions or box • Part number, description of the part and quantity needed
This information will help us get the proper part to you faster
STEP 1
CONNECT RIGHT UP LEG (A3) TO RIGHT DOWN LEG (A4) USING
CROSS BOLTS (H) WITH SCREWDRIVER , CONNECT RIGHT UP
LEG(B3) TO RIGHT DOWN LEG(B4) USING CROSS BOLTS (H)
WITH SCREWDRIVER, REPEAT THIS ASSEMBLY STEP TO
ASSEMBLE THE LEFT LEGS.
B1
A1
H
B2
A2
This unit is intended for use only with
the products and maximum weights
indicated. Use with other products or
products heavier than the maximum
weights indicated may result in instabil-
ity causing possible injury. Furniture can
tip over or break if improperly moved.
Have a friend help to lift and carry the
unit to its new location.
MODEL: 11222461
LADDER SHELF
support@fourstari.com or
B3
A3
H
H H
B4
A4
Shelf weight limit:
10 lbs. (4.53 kg).
Shelf weight limit:
15 lbs. (6.8 kg).
Shelf weight limit:
15 lbs. (6.8 kg).
Shelf weight limit:
20 lbs. (9.07 kg).
BEFORE YOU BEGIN, PLEASE READ ASSEMBLY
INSTRUCTIONS CAREFULY AND FOLLOW THEM
STEP BY STEP.
NO
A LEG
B LEG
C BAR
D PANEL
E PANEL
F PANEL
if calling locally G PANEL
H CROSS BOLT
I BOLT
J BOLT
K ALLEN WRENCH
STEP 2
ATTACH STEP 1 FINISHED
PARTS TO BAR(C) AND
LEGS USING CROSS
BOLTS(H) WITH
SCREWDRIVER AS SHOWN,
CONNECT PANEL(D),
PANEL(E), PANEL( F),
PANEL( G ) AND LEGS
USING BOLTS (I) WITH
ALLEN WRENCH (K).
CONNECT LEGS (A) TO
LEGS (B) USING BOLTS (J)
WITH ALLEN WRENCH (K).
DON'T TIGHTEN ALL
BOLTS AT FIRST, AFTER
ALL PARTS ARE IN PLACE
THEN TIGHTEN ALL BOLTS.
NOTE, BEVELLING EDGE ON THE FRONT.
IF NECESSARY, PLEASE FOLLOW BELOW INSTRUCTION
TO PREVENT PRODUCT TIP OVER.
HARDWARE LIST
WALL PLUG EYELET SCREW
1/4''
DRILL BIT
WALL
HARDWARE LIST
A2
A3
A1
A4
B3
B2
B4
B1
30CM
35CM
H
L
C
A1
J
J
D
I
B3
B1
E
I
A2
F
I
B4
B2
G
I
QTY
2 SETS
CABLE TIE
B
A
1
WALL
CABLE
TIE
QTY
4 PCS
4 PCS
1 PC
1 PC
1 PC
1 PC
1 PC
10 PCS
16 PCS
2 PCS
1 PC
H
R
A3
I
I
A4
I
I