Dyna-Glo DGH485CRP Manual De Instrucciones página 22

Operation instructions
LiGhtinG the GriLL with a MatCh
1. Open the lid.
2. Insert a match in the end of the match holder that is installed on the inside of the cabinet door.
3. Light the match.
4. Immediately place the lit match through the spaces in the grill grates near the ports of the burner
between the heat tents as shown. Make sure the lit match is close to the burner ports.
5. Press in the control knob that operates the burner and rotate
position for the main burners, and
6. Repeat steps 2~5 to light additional burners.
7. Adjust burners to desired cooking settings.
Make sure all burner controls are off except for the burner being lit and the
burners that have been lit.
if ignition does not occur in 5 seconds, turn the burner control(s) OFF
and repeat the lighting procedure.
Main Burner Match Lighting
SHUTDOWN INSTRUCTIONS
1. Turn all control knobs
2. Close valve at tank fully by turning
3. Close lid.
Turn off LP supply at cylinder when appliance is not in use.
for the SearPLUS™ burner which should light immediately.
CAUTION
warninG
O
clockwise to the OFF position.
clockwise.
22
counter-clockwise to the
O
. wait 5 minutes,
Side Burner Match Lighting
high