Numeric Buttons - Lenco KCR-200 Manual De Usuario

FRONT PANEL
1. STANDBY / SOURCE
Press to turn on the unit. When it is turned on, press this button will toggle between DAB+, FM and Bluetooth mode. Press and
hold to turn off and go to Standby mode
2. LIGHT ON / OFF
Slide to turn on or turn off the downward lighting

3. NUMERIC BUTTONS

Press to direct tune to the stored preset FM channel
4. DISPLAY
5. SCAN / ST-MONO / PAIRING
DAB+: Press to start auto-scanning all available DAB+ stations
FM: Press to toggle between FM Stereo and Force Mono reception. Press and hold to start the full auto-scanning and store the
available FM channel
BT: Press and hold to disconnect the current connection and start to search another new Bluetooth device
/ MIN.
6.
DAB+: Press to display the previous station information
FM: Press to tune to different frequency. Press and hold to auto-scan the previous available channel
BT: Press to skip to the previous track
Timer Setup: Press to setup the minute setting
/ SEC.
7.
DAB+: Press to display the next station information
FM: Press to tune to different frequency. Press and hold to auto-scan the next available channel
BT: Press to skip to the next track
Timer Setup: Press to setup the second setting
/ INFO/MENU / CLOCK SET
8.
DAB+/FM: Press to display station information. Press and hold to enter the Menu for setting change
BT: Press to toggle between pause and resume playback operation
Standby mode: Press to enter clock setup operation
9. TIMER / ENTER / MEMORY
Press to enter the Timer Setup
DAB+/FM: During Menu operation, press to select the change setting. During non-Menu operation, press and hold to store the
preset channel as desired
10. – VOLUME +
Adjust the volume control
11. IR Receiver Window
6