Spout Installation; Handle Installation - Pfister CONTEMPRA 49 Serie Manual De Instrucciones

7
7E
7D
7A
7B
7C
7E

7 HANDLE INSTALLATION

Thread Valve Adapters (7A) onto the Valve End Bodies (7B) and tighten so that the
Valve Adapters (7A) sit on the surface of the Valve Body Washers (7C). Place Plastic
Seal Rings (7D) against the bottom of Handle Hubs (7E). Connect Handles (7F) onto
Valve Adapters (7A).
Be sure Valves and Levers are in the "OFF" position. Secure handles by holding the Lever
(7G) in place and tighten Handle Hubs (7E) by rotating them in a clockwise direction. To
remove handles, rotate Handle Hubs (7E) in a counterclockwise direction.
7F
7F
7E
7D
7A
7B
7C
7G
ENGLISH
8
8E
8D

8 SPOUT INSTALLATION

Insert Lift Rod (8A) into hole at the back of Spout (8B). Place Plastic Seal Ring (8C)
against the bottom of Spout Body (8D). With Spout (8E) facing forward, carefully
install the Lift Rod (8A), Shank (8F) and receiving Tube (8G) through the center hole
of sink (8H).
9
9 SECURING FAUCET
From underneath sink, secure the faucet by placing the Metal Washer (9A) and the Long
Nut (9B) ( 7 / 16 hex.) onto the Mounting Post (9C). Make sure that the bumps on the
Metal Washer (9A) are facing up. Tighten using a Slotted screwdriver or an adjustable
wrench until the faucet is firmly connected to the sink.
Do not over tighten!
3
8C
8A
8F
8G
8H
9C
9A
9B
8A
8B