Cleaning And Maintenance - IKOS ECOpellets Insert Manual Del Usuario

CLEANING AND SUPPORT
In order to achieve an optimal operating performance, it's essential to carry out a set of cleaning
EN
and maintenance procedures. To do so in a convenient way, use a household vacuum cleaner.
The cleaning operation should be carried out after each burn of approximately 30 kg. To
prevent any accidents, the cleaning and maintenance operations must be performed with the
disconnected from the power socket and after complete cool down.
You can use an ash vacuum cleaner for this task.
The deterioration of parts due to the lack of cleaning will void the warranty.
Daily cleaning – Firing basket, grate and ash basket
By opening the door using the accessory, you have access to the inside of the equipment. As a
first operation you should remove the grate, if there is any ash accumulated in it, you should
tilt the grate still inside the equipment in order to ensure that the ash falls into the ash drawer.
Then remove the firing basket and brush or vacuum it so that the holes in the workpiece are
unobstructed.
Clean the place where the basket is placed to avoid obstructing the passage of combustion air
and return the components to their proper places.
Additional cleaning
Additional cleaning should be caried out for every 600-800 kg of pellets consumed.
Begin cleaning for the tasks described previously. and disconnect the equipment from electrical
power.
Once the 3 pieces have been removed, continue removing the baffle plate.
To remove the baffle plate that is installed in the upper part of the combustion chamber, it will
be necessary to move the first one slightly upwards in the anterior part of it, then sliding it over
the vermiculite.
When the baffle plate is removed, the vermiculite plates are released and can be removed.
Start removing from the sides and only then remove the back plate. Here you can see the plates
that separate from the rear smoke passage.
Remove the DIN 912 M6x12 screws that hold the bottom plates with the help of a hexagon
socket wrench nº 5.
EN // 111
USER'S MANUAL