Replacing Components; Cleaning The Interior - Virtus _70/40 CPGS Instalación, Uso, Mantenimiento

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 47
- Igniter or igniter wire defective.
PILOT BURNER GOES OUT DURING USE.
Possible causes:
- Insufficient gas supply pressure.
- Defective gas tap or valve.
- Defective thermocouple or insufficient heating.
- Thermocouple incorrectly connected to gas tap or
valve.
-
The gas cock and/or gas valve knob is not being
pressed enough.
THE MAIN BURNER DOES NOT LIGHT (EVEN
THOUGH PILOT IS LIT).
Possible causes:
- Insufficient gas supply pressure.
- Blocked tubing or nozzle.
- Defective gas tap or valve.
- Defective burner (gas outlet holes clogged).
HEATING CANNOT BE ADJUSTED.
Possible causes:
- Defective gas tap
ELECTRIC PASTA COOKER
THE APPLIANCE DOES NOT HEAT.
Possible causes:
- Defective heating element.
- The selector is broken.
- Safety thermostat faulty.
- Safety thermostat tripped.
HEATING CANNOT BE ADJUSTED.
Possible causes:
- The selector is broken.
- Safety thermostat tripped.

19. REPLACING COMPONENTS

REMINDERS FOR REPLACING COMPONENTS
SHUT THE GAS SHUT-OFF VALVE
AND/OR SWITCH THE APPLIANCE OFF
AT THE MAIN SWITCH INSTALLED
UPSTREAM.
AFTER REPLACING A GAS SYSTEM
COMPONENT, CHECK FOR GAS LEAKS
AT CONNECTION POINTS.
DISCONNECT THE APPLIANCE ELECTRIC
SUPPLY, IF PRESENT, BEFORE CARRYING
OUT ANY OPERATION.
AFTER REPLACING AN ELECTRICAL
SYSTEM COMPONENT, CHECK IT IS
CORRECTLY WIRED.
GAS PASTA COOKER
REPLACEMENT OF GAS TAP, WATER INLET TAP,
BURNER,
PILOT
ELECTRIC IGNITION AND IGNITER.
- Open the door.
- Empty the well completely.
- Remove the front panel.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
ELECTRIC PASTA COOKER
REPLACEMENT OF HEATING ELEMENT, WATER
INLET TAP, SELECTOR, SAFETY THERMOSTAT AND
INDICATOR LIGHT.
- Open the door.
- Empty the well completely.
- Remove the front panel.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.

20. CLEANING THE INTERIOR

Check the condition of the inside of the appliance.
Remove any built-up dirt.
Check and clean the fumes exhaust system.
23
BURNER,
THERMOCOUPLE,

Publicidad

Tabla de contenido
loading

Tabla de contenido