Operating Instructions - Kobalt SGY-AIR171JH Manual De Instrucciones

ASSEMBLY INSTRUCTIONS
5. Attach lead hose (C) to air inlet (F).
(See Figure 6)
NOTE Use thread sealant tape and wrench (not
provided) for airtight connection.
6. Connect air supply hose to lead hose (C).
NOTE Use thread sealant tape and wrench (not
provided) for airtight connection.
7. Attach air tool to the outlet (G) of air hose (B) in
the retractable hose reel (A). (See Figure 7)
NOTE
The bumper (I) can be adjusted to any
position on the air hose (B). Pull some air hose (B)
out until it clicks in place, loosen the screws on the
bumper, slide the bumper (I) closer to hose guide
(H), then tighten the screws.
NOTE
The roller bracket (J) can be adjusted to the
best angle/position for the smoothest operation of
hose reel (A) when the hose reel is mounted.
Remove three set screws (K) and fix plate (M),
rotate the roller bracket (J) to the desired position,
then re-install the fix plate (M) and three set screws
(K) tightly.

OPERATING INSTRUCTIONS

1. To extend air hose (B), slowly pull air hose to desired length. The air hose must be
making an audible "click" when released to maintain its length. It may be necessary
to pull air hose beyond desired length to keep it from automatically retracting.
2. To retract, slowly pull air hose (B) until clicking stops. Then, let air hose
automatically draw back until the bumper (I) stops against the hose guide (H).
NOTE To avoid damaging the hose reel (A), always hold on to air hose (B) while it is
rewinding.
6
7
7