G Operating instruction
1. Controls and displays
1.
Display and operating display
2.
The illuminated ring visually indicates the indoor air quality
Green: good room air;
Yellow: normal room air;
Red: bad room air.
• Reminder function for filter change:
when the air purifier detects that the filter has reached the saturation
level, the operation indicator flashes red continuously. The filter should
then be replaced to ensure sufficient air purification.
• With daily use, the combi-filter should be used up after approx. 6 - 12
months.
• The filter is not washable.
• An unpleasant odour during operation may indicate that filtered
substances are decomposing in the filter (e.g. bacteria) and it needs to
be replaced or ventilated in the sun.
• Vacuum the filter and the inner housing every 1 to 2 months to remove
coarse dirt. Then place the filter outdoors in direct sunlight for approx.
3 hours to dry it and eliminate any bacteria, viruses etc. that may be
present through the UV rays.
• The filter can then possibly be reused. The filter must be replaced after
1 year at the latest. On the one hand, there is a risk that it will no
longer completely remove the particles mentioned from the air or that
the pollutant particles already in the filter will be released again. The
activated charcoal also loses its effect when unpacked.
• After replacing the filter, you must press the
for approx. 7 seconds to cancel the alarm.
3.
Air outlet opening
4.
Front panel
5.
Air intake opening
6.
Filter unit
7.
Base plate
8.
ON/OFF button:
Touch the icon to switch on the device. The buzzer sounds once. Blue
light and the low wind speed indicator L light up. If you touch the button
again, the buzzer sounds once and the device switches off.
Note
The device records the working modes when you switch it off if you
do not unplug it. If, for example, automatic was selected - the device
starts again with automatic.
9.
Timer button:
When the device is switched on:
Running time of 2 - 4 - 8 hours or WLAN control preselectable. After the
selected hours have elapsed, the device stops operating. On the WLAN
setting, the device is on standby and waiting for commands via the APP
control.
See also the section on WLAN/APP operation
10.
Speed button:
When the device is switched on:
Fan speed level L - M - H - Auto.
The buzzer sounds each time the switch is made. An LED next to it
indicates the selected speed.
L Low speed
M Medium speed
H High speed
Auto: the device regulates the fan speed independently according to
the air quality. The illuminated ring (2) shows the air quality in colour.
If the humidity in the room is very high, condensation can form on the
sensor and negatively affect the display and cause switching back and
forth in automatic mode. In this case, use the air purifier with a manual
speed setting.
2
11.
12. Control lamps. An LED lights up next to the symbols to check the
!
Thank you for choosing a Hama product.
Take your time and read the following instructions and information completely.
Please keep these instructions in a safe place for future reference. If you sell
the device, please pass these operating instructions on to the new owner.
ON/OFF button (8)
2. Explanation of warning symbols and notes
Risk of electric shock
This symbol indicates a risk of electric shock from touching product parts
carrying hazardous voltage.
Warning
This symbol is used to indicate safety instructions or to draw your attention
to specific hazards and risks.
Note
This symbol is used to indicate additional information or important notes.
3. Package contents
• 1 air purifier
• 1 combi filter
• These operating instructions
4. Safety instructions
• The product is intended for private, non-commercial use only.
• The product is intended only for use inside buildings.
• Use the product only for the intended purpose.
• Protect the product from dirt, moisture and overheating and use it in dry
rooms only.
• Always pull directly on the plug when disconnecting the cable, never on
the cable itself.
• Do not use the product in the immediate vicinity of heaters, other heat
sources or in direct sunlight.
• As with all electrical products, this device should be kept out of the reach
of children.
• Do not operate the product outside the power limits specified in the
technical data.
• Do not use the product in areas in which electronic products are not
permitted.
• Do not use the product in a damp environment and avoid splashing water.
• Do not place the product near interference fields, metal frames, computers,
TVs, etc. Electronic devices and window frames can negatively affect the
product's functionality.
• Do not drop the product and do not expose it to any major shocks.
Light button:
When the device is switched on:
Press once, the buzzer sounds once and the LED light (2) changes to soft
mode. Press again to switch the light to standard mode. Press again to
switch off the light.
settings.
Important information - Quick-reference guide
• This quick-reference guide contains the most important basic
information, such as safety instructions and the steps necessary
to operate the product.
• To help protect the environmental and conserve valuable raw
materials, Hama does not issue a printed manual and instead
makes this available exclusively as a PDF download.
• The full text of the manual is available at the following internet
address: www.hama.com -> 00186437 -> Downloads
• Save the manual on your computer for reference and print them
out if possible.