Storage Instructions; Storage - ryan 744865D Manual Del Operario

Escarificadora-rastrillo de empuje
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

REN-O-THIN

STORAGE INSTRUCTIONS

to prevent possible explosion or ignition of
vaporized fuel, do not store equipment with fuel
in tank or carburetor in enclosure with open flame
(for example, a furnace or water heater pilot
light).
After daily usage of unit.
1. Wash the unit with water after the engine has
cooled down.
2. Check the reel blades for damage. replace any
cracked, broken, bent or worn blades.
3. Check the engine oil level and inspect the air
cleaner for excessive dirt or any obstructions.
4. Service engine according to engine
manufacturer's recommendations. refer to
engine manual for all recommendations.
Before the equipment is put into storage for
any period exceeding 30 days, the following
steps should be taken.
1. Drain all fuel from the fuel tank and fuel lines.
2. Start the engine and run until all the fuel is used
from the carburetor float bowl and the engine
stops.
3. While the engine is still warm, drain the
crankcase oil and replace with the proper weight
oil corresponding to the season the equipment
will next be used.
4. remove the spark plug and squirt a small
amount of engine oil into the cylinder. Slowly
pull the starter a few times to distribute oil in the
cylinder and reinstall the spark plug.
5. Check the reel for damaged blades and replace
as needed.
6. Lubricate the wheel bearings with a standard
lithium based lubricant.
To put the equipment into service after an
extended period of storage:
1. Check for loose parts and tighten if necessary.
2. Check for damaged blades and replace as
necessary.
3. Fill the fuel tank and then check the engine oil
level.
4. Start the engine and check for fuel leaks. repair
any leaks before operating the unit.

STORAGE

15

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

744877a

Tabla de contenido