Optional Programming - Stobag MOVENO DSRC-E Instrucciones Para La Instalación Y El Uso

4.2) Programming of positions "0" and "1"
A remote control memorised in Mode I must be used to program the positions. The manoeuvres will remain hold-to-run until positions "0" and
"1" have been memorised in the control unit. To begin with, the direction of the motor is not defined but after point 1 in table A3 has been
completed the direction of the motor is automatically assigned to the remote control buttons.
Follow the procedure in table A3 to program the "0" and "1" positions:
Table "A3" Programming of positions "0" and "1"
Press and hold buttons ▲ or ▼ of a memorised remote control until the awning is fully
1.
closed and the motor automatically stops.
Press and hold button ▼ that lowers the awning.
2.
Release button ▼ when the awning is in the desired position ("1").
3.
If necessary use the ▼ and ▲ buttons to adjust the position.
Press and hold button ■ of the transmitter until you hear a beep
4.
(after about 5 seconds) then release it.
Release and press again button 5 for another 5 seconds until ■ rapid beeps are heard.
5.
Press button ▼ until 3 beeps are heard and a short up and down movement occurs
6.
indicating that the position has been memorised.

4.3) Optional programming

Optional programming is only possible after positions "0" and "1" have been programmed.
4.3.1) Memorisation of the intermediate position "I"
When an intermediate position "I" is memorised the awning can be manoeuvred into the "I" position by pressing the ▲ and ▼ buttons of the
transmitter together.
Follow the procedure shown in table A4 to memorise the intermediate position:
Table "A4" Programming of the intermediate position "I"
Using buttons ▲ ■ ▼ of a remote control, move the awning into the "I" position to
1.
be memorised.
Press and hold down button ■ until you hear a beep (after about 5 seconds).
2.
Release and press again button ■ for another 5 seconds until 4 rapid beeps are heard.
3.
Press buttons ▼ and ▲ together until 3 beeps are heard, indicating that the position
4.
has been memorised.
4.3.2) Programming of the closure torque reduction (RDC)
The torque reduction is a programmable function that prevents excessive tension on the fabric by reducing the pulling torque by approximately
50% just before the awning is fully retracted against the box. This function is activated automatically after programming positions 0 and 1
(programming is always at maximum force) but can be deactivated (or re-activated) if required.
Note: automatic activation of the RDC function does not occur if position programming is performed using programmers MA 2000; in these
cases the function can be activated manually as required.
Table "A5" Programming the torque reduction (RDC)
Press and hold down button ■ of a previously memorized transmitter until you hear a
1.
beep (after about 5 seconds).
Release and press again button ■ for another 5 seconds until 4 rapid beeps are heard.
2.
Press button ■ until 3 beeps indicate that the RDC function has been activated.
3.
36
Example
5s
5s
Example
5s
5s
Example
5s
5s
www.stobag.com