Andis WDS-1 Instrucciones De Uso Y Cuidado página 3

products are being used or where oxygen is being
administered.
7. Do not use this appliance with a damaged or broken foil
or cutter, as injury to the skin may occur.
8. Always attach plug to appliance first, then to outlet.
To disconnect, turn all controls to OFF, then remove plug
from outlet.
9. For the purposes of recharging the battery, only use the
detachable supply unit provided with this appliance.
10. WARNING: Detach the hand-held part from the supply
cord before cleaning it in water.
11. THIS PRODUCT INTENDED FOR HOUSEHOLD USE.
Suitable for cleaning under an open water tap
Detachable supply unit
SAVE THESE INSTRUCTIONS
OPERATING INSTRUCTIONS
(Refer to Figure A for this section)
CHARGING SHAVER
The shaver has not been charged at the factory. Please charge the
shaver for a minimum of 90 minutes before the first use for maximum
performance.
This battery charger is intended for use with Andis model WDS-1 lithium-ion
battery with a rated capacity of 3.7V
AC adapter from the carton. Plug the adapter into a 100-240V AC outlet,
or according to your local power standards. Note that the shaver ON/OFF
switch must be in the OFF position for the battery to charge. Plug the cord
adapter directly into the inlet on bottom of shaver. The red charging
indicator light on the shaver will turn on. After battery is fully charged, the
charging indicator light will turn green.
When using the charging stand, plug the cord adapter directly into the inlet
on the back of the charging stand. The red charging indicator light on the
600mAh. Remove the shaver and
3