ManoMano HL-PHL-CTL-I Manual De Instrucciones página 13

Power source and interface:
Includes 6 power and interface jacks
Instructions
Setting up DMX address code
Each controller uses 3 DMX addresses and has a coding switch to choose the address. This switch has a binary code that
establishes the original code of the DMX address from 1 to 9, with 1 being the lowest and 9 being the highest. You can
choose up to 511 address codes. The original address of the DMX code is number added to the switch code from 1 to 9.
Flip the coding switch down (ON is the 1 position), otherwise the bit value is 0.
The DMX signal received with the switch FUN(10)=OFF(ON is 0).
Example 1:
Look at the following image, if you want to set the address code as 37, you can only choose the first, third and sixth coding
switches. The number added in coding the switch value from 1 to 9 is 32+4+1, meaning the original code for the DMX512
address is 37.
13