Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
TO ERASE ALL CODES FROM MEMORY
1
Press and HOLD the "LEARN" button until the LED flashes
(approximately 6 seconds). All codes are now erased.
IMPORTANT NOTE: If multiple devices are programmed to
the switch, ALL devices will be erased.
TROUBLESHOOTING
If the light does not operate, below are some troubleshooting
suggestions.
Symptom
Solution
The light does not
• Verify the power is ON. Check the fuse box or
operate from the
circuit breaker.
switch.
• Verify the light bulb is "good".
• Press the top half of the Smart Light Switch
to make sure it is ON.
• Ensure the device is properly grounded.
• Verify the electrical Line and Load wiring is
correct. If you are unsure which wires are
Line and Load, reverse the Line and Load
wire connections.
The light does not
• Make sure you are pressing the remote
operate from the
control button selected to operate the light
remote control.
control.
• The LED on the remote control should glow
when the button is pressed, if not replace the
battery.
• Program the remote control to the Smart
Light Switch.
The LED flashes for
• This indicates an issue with low voltage or
improper grounding. Ensure the device is
more than 10
properly grounded. Contact a qualified
minutes and cannot
electrician.
enter the
programming
mode.
114A4380C
To avoid electric shock, press the switch to the OFF position when
changing the light bulb.
www.chamberlain.com
1-800-528-9131
Wi-Fi
is a registered trademark of Wi-Fi Alliance.
®
© 2017, The Chamberlain Group, Inc.
All Rights Reserved
Publicidad
Tabla de contenido
