How To Use; Control Panel And Remote Control - Kenmore Elite 580.77087710 Manual De Uso Y Cuidado

WARNING
To reduce the risk of fire, electric shock, or injury to persons, read and follow this entire Use & Care Guide,
including the Important Safety Instructions, before operating this air conditioner.

Control Panel and Remote Control

POWER
1
Press to turn the air conditioner ON or OFF.
FAN SPEED BUTTON
2
Press to set the fan speed to Low, Medium, or High.
The display will show one, two or three bars.
DELAY ON/OFF TIMER
3
Delay ON - When the air conditioner is off, set it to
automatically turn on from 1 to 24 hours later, at its
previous mode and fan settings.
Delay OFF - When the air conditioner is on, set it to
automatically turn off from 1 to 24 hours later.
Each press of the Timer button advances the timer
by 1 hour. After the last press the display returns to
the temperature setting.
OPERATION MODE BUTTON
4
• Press the Mode button to cycle between 4 types
of air conditioner operation: Cool / Energy Saver
/ Fan Only / Dry.
Cool - This mode is ideal on hot days to cool and
dehumidify the room quickly. Use the Temp
buttons to set the desired room temperature and
use the Fan Speed button to set the desired fan
circulation speed.
Energy Saver - In this mode the compressor and
fan turn off when the set temperature is achieved.
Approximately every 3 minutes the fan turns on to
allow the unit sensor to accurately determine if more
cooling is needed.
Fan Only - In this mode the fan circulates air but
the compressor does not run. Use the Fan Speed
button to set fan speed to High, Medium or Low. In
this mode, you can not adjust the set temperature.
Dry - This mode is ideal for rainy and damp days
to dehumidify the room rather than cooling it
significantly. Humidity is removed from the room by
the combination of compressor operation and the
fan speed fixed at Low. The compressor and fan
turn off once the set temperature is reached. Fan
speed cannot be adjusted in Dry mode.

HOW TO USE

TEMPERATURE CONTROL
5
The thermostat monitors room temperature to
maintain the desired temperature. The thermostat
can be set between 60 °F–86 °F (16 °C–30 °C).
Press
temperature setting.
REMOTE CONTROL SENSOR
6
Receives signal from Remote Control.
FILTER RESET
7
The Filter Reset LED lights up to notify you that the
filter needs to be cleaned. After cleaning the filter,
press Temp
to turn off the Filter Reset light. (The filter reset must
be done using the control panel, not the remote
control.)
NOTE: This feature is a reminder to clean the air
filter for more efficient operation. The LED light
turns on after 250 hours of operation.
SMART CONNECT FUNCTION
8
SMART icon LED turns ON when unit is successfully
connected to the internet.
AUTO RESTART
If the air conditioner turns off due to a power
outage, it will restart automatically once the power
is restored, with the same settings as were set before
the unit turned off.
ENERGY SAVER
The unit defaults to the Energy Saver mode each
time the unit is switched on except in Fan mode or
when power is restored after an electrical power
outage.
CAUTION
The remote control will not function properly if
the AC infrared sensor is exposed to direct light
or if there are obstacles between the remote
controller and the air conditioner.
11
Remote Control
or arrows to increase or decrease
and together on the control panel