Work Pro CLUBMASTER 1 PH Instrucciones De Usuario página 6

EN
MIXER INPUT/OUTPUT SECTION
25
33
25. MONITOR OUTPUT
It is possible to use this connection like an independent output.
26. AC INPUT
Use the cord incorporate in order to supply power to the unit. Plug into adequate AC outlet
27. VOLTAGE SELECTOR
Allows to select the main voltage between 110 V or 230 V AC.
NOTE: Be sure to set it properly before operating with this unit
28. MICROPHONE INPUT 1
Balanced input through Combi connector. Despite of the use an unbalanced microphone,
in order to reduce interferences or hum, it is advisable to use balanced microphones.
29. DJ MICROPHONE INPUT 2
Balanced input through Combi connector. Despite of the use an unbalanced microphone,
in order to reduce interferences or hum, it is advisable to use balanced microphones.
30. GND SCREW
When an audio system is connected, is very useful to create a "ground loop" between units in
order to prevent hum. So is possible to unit the ground connections to mains earth forming a
loop.
31. FIRST INPUT
Depending on the channel, you can select different source types between PHONO, LINE or CD
32. SECOND INPUT
Depending on the channel, you can select different source types between PHONO, LINE or CD
33. MASTER OUTPUT
Acting over Master fader (21), it is possible to use this output to connect to an amplifier system.
It disposes of separate Left/Right output
34. PHANTOM SELECTOR
In ON position, this selector allows to connect microphones with phantom power supply in MIC 1 and
MIC 2 inputs.
CLUB MASTER 1 PH
CAUTION
RISK OF ELECTRIC SHOCK
C L U B M A S T E R1 P H
DO NOT OPEN
WARNING:
SHOCK HAZARD - DO NOT OPEN
AVIS:
RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR
User Manual/Manual de Instrucciones
27
R
R
32
31 30
Pag 5
26 34
ON OFF
PHANTOM +48
ON OFF
PHAMTON +48
34
28
29