Pfister Treviso 8P5 Serie Manual Del Usuario página 3

7
7A
7G
7D
7C
7E
7 TRIM FLANGE ATTACHMENT
Position Flange (7A) on Valve (7B) with Drain Hole (7C) at the bottom. Place
Protective Washer (7D) on the short end of the reversible Retainer Sleeve (7E).
Screw Retainer Sleeve (7E) onto threaded section of the Stem and Bonnet (7G).
Tighten Retainer Sleeve (7E) by hand until Flange (7A) is snug to finished wall
surface. If the short end of the Retainer Sleeve (7E) is too short, reverse it to
use the longer end.
8
8A
8D
8C
8E
8 HANDLE ATTACHMENT
Screw Stem Extender (8A) onto Valve Stem (8B). Thread Set Screw (8C) into
Handle (8D) and thread it in only three to four turns. Place Handle (8D) onto
Stem Extender (8A) and tighten Set Screw (8C) by using Hex Wrench (8E) that
is provided.
Make sure Set Screw (8C) is securely tightened to handle (8D).
7B
7C
8B
ENGLISH
9
9 SHOWER ARM INSTALLATION
Insert the end of Shower Arm (9A) through the Shower Flange (9B).
Apply PTFE plumber's tape to both ends of Shower Arm (9A) according to
manufacturer's instructions. Screw the end of Shower Arm (9A) into pipe elbow
inside the wall. Slide Shower Flange (9B) tight to the wall.
10 UNIT START UP
Turn on hot and cold water supplies, and check all connections for leaks.
11
11A
11 VALVE FUNCTION
By rotating the Lever Handle (11A) slightly counterclockwise, the valve will
be fully activated to the "COLD" position. The water temperature can be
increased by continuing to rotate the Lever Handle (11A) in a counterclockwise
direction.
3
9B
9A
OPEN
CLOSED
FULL COLD
FULL HOT