Safety Precautions - RCA RT1511 Manual De Usuario

SAFETY PRECAUTIONS

WARNING:
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK). NO USER-SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED
PERSONNEL.
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE
THIS UNIT TO RAIN OR MOISTURE. DO NOT PLACE
EN
OBJECTS FILLEDWITHLIQUIDS ONORNEARTHISUNIT.
THE MAINS PLUG IS USED AS DISCONNECT DEVICE
AND IT SHOULD REMAIN READILY OPERABLE DURING
INTENDED USE.IN ORDER TO DISCONNECT THE
APPARATUS FROM MAINS COMPLETELY, THE MAINS
PLUG SHOULD BE DISCONNECTED FROM THE MAINS
SOCKET OUTLET COMPLETELY.
Placement Information
• Do not use this unit in places which are extremely hot, cold,
dusty, or humid.
• In a cabinet, allow about 2.5cm (1 inch) of free space around
the unit for adequate ventilation.
• Place the unit on a flat and even surface.
• Do not restrict the air flow of this unit by placing it somewhere
with poor air flow, by covering it with a cloth, or by placing it
on bedding or carpeting.
Safety Information
• When connecting or disconnecting the AC power cord, grip
the plug and not the cord itself. Pulling the cord may damage
it and create a hazard.
• When you are not going to use the unit for a long period of
time, disconnect the AC power cord.
Condensation Information
• When left in a heated room where it is warm and damp,water
droplets or condensation may form inside the unit.When there
is condensation inside the unit, the unit may not function
normally. Let the unit stand for 1-2 hours before turning the
power on, or gradually heat the room and let the unit dry before
use.
Rating Plate Location
The rating plate is located on the rear of unit.
This product complies with DHHS rule 21 subchapter
J parts 1040-10 and 1040-11 at date of manufactured.
This Class B digital apparatus complies with
Canadian ICES-003.
2
All manuals and user guides at all-guides.com
within a triangle alerts you to
uninsulated dangerous voltage
within the product's enclosure
that could cause an electric shock.
CAUTION:
DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY
REPLACED.REPLACEONLYWITHTHESAMEOREQUIVALENT
TYPE.
SHOULD ANY PROBLEMS OCCUR, DISCONNECT THE AC
POWER CORD AND REFER SERVICING TO A QUALIFIED
TECHNICIAN.
DO NOT PLACE ANYTHING DIRECTLY ON TOP OF THE UNIT,
IT MAY CAUSE DAMAGE.
USE OF CONTROLS OR ADJUSTMENTS FOR PERFORMANCE
OF PROCEDURES OTHER THAN THOSE SPECIFIED MAY
RESULT IN HAZARDOUS RADIATION EXPOSURE
THE APPARATUS SHALL NOT BE EXPOSED TO DRIPPING OR
SPLASHING AND THAT NO OBJECTS FILLED WITH LIQUIDS,
SUCH AS VASES, SHALL BE PLACED ON APPARATUS.
The lightning flash
with an arrowhead
of important operating, maintenance and
servicing instructions in this user's manual.
FCC Information
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2)this device must accept any interference received,
including interference that may cause undesired
operation.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio / TV technician
for help.
WARNING: Changes or modifications to this
unit not expressly approved by the party responsible
for compliance could void the user's authority to
operate the equipment.
The exclamation point within a
triangle alerts you to the presence
The symbol for Class II
(Double Insulation)