Maintenance And Storage - Remington REM-16-TTC-O Manual De Usuario & Instrucciones De Operación

Lighting Instructions
Models 16-TTC / 32-TTC / 47-TTC (CONT)
9. Once lit, keep the plunger depressed for thirty
(30) seconds. Then release the plunger, and
if the burner stays lit, remove and extinguish
the match. You will know that the burner is lit
when the mesh screen begins to glow red.
10. If the burner does not stay lit, repeat the
lighting process. If the heater does not light
after several attempts, be sure you are getting
fuel to the burner. The faint smell of gas will
tell you if the fuel is flowing. If not, there may
be a problem with your LP cylinder. Take it
back to your local dealer for replacement.
11. Once the burner is lit, turn Regulator Control
Knob to desired setting (HI) / (MED) / (LO ).
12. Light all burners when maximum heat is
desired. Follow Lighting Instructions steps
1-11. The second and third burner should be
lit separately. Do Not Attempt to light second
burner off the first burner. Be sure NOT to
point burners at one another.
1. Inspect your heater before each use.
Check all connections for leaks, following
the procedure outlined on Pages 7 and 8.
Check the Regulator Hose (dual burner
models only) for any cracks, breaks or wear.
If the hose is damaged replace it with the
correct manufacturers part. Heater should be
inspected before each use and once annually
by a qualified service person.
© 2017, Pinnacle Climate Technologies, Inc.
NEVER LEAVE HEATER UNATTENDED
Operation
To Turn Off Heater
1. Turn the valve on the LP cylinder CLOCKWISE
2. Turn the heater regulator knob to the
3. Tightly close the gas shutoff valve on the LP
4. Remove the heater from the LP cylinder by
NOTE: ALWAYS INSPECT HEATER BEFORE
USE AND AT LEAST ANNUALLY BY A
QUALIFIED SERVICE PERSON.

Maintenance and Storage

2. After use, always disconnect the heater
10
WHILE BURNING OR WHILE
CONNECTED TO A FUEL SOURCE
to stop the flow of fuel.
position and wait at least fifteen (15) minutes for
the heater to cool.
cylinder after each use.
reversing the steps in Connecting Heater to
LP Cylinder on Page 7. DO NOT store the LP
cylinder with the heater still attached or in an
enclosed area.
EXTREMELY HOT during
DANGER
operation. Do Not touch any
metal components while in operation. Keep
gasoline and any other flammable liquids
away from the heater.
Never bring or store a
DANGER
propane cylinder indoors.
DO NOT insert the lit match
CAUTION
into the air inlet holes in the
mixing tube.
from the LP cylinder, and store the heater
separately from the tank. Be sure to close
the tank valve after use, and before storage.
The LP cylinder should be stored outdoors in
accordance with chapter 5 of the Standard for
Storage and Handling of Liquefied Petroleum
Gases (ANSI/INFPA 58).
Propane Tank Top Heater User's Manual
(OFF)