Midwest Pet Gate 2929SW Manual Del Usuario página 3

ASSEMBLY INSTRUCTIONS
For Installation Without Extensions
1. Locate the 4 Threaded Spindle Bolts. Before you begin,
turn the Adjustment Wheels clockwise until they are close
to the Plastic Pads. NOTE: The Adjustment Wheel should
not touch the Pad. If it does it could get stuck.
2. Insert the 4 Threaded Spindle Bolts into the holes of the
Plastic Inserts in the four ends of the gate frame as shown.
NOTE: The Plastic Inserts are not threaded. The Threaded
Spindle Bolts should slide into the inserts without any
resistance. Push the Threaded Spindle Bolts all the way in
until each adjustment wheel hits the gate frame.
Positioning and Attaching the Mounting Cups to the Opening
Your gate is a pressure-mounted gate, therefore it is not necessary to use the Mounting Cups. However, using the
Mounting Cups will affix your gate more firmly in the opening, so you may choose to use them in all applications. If you
choose not to use the Mounting Cups you may skip to Step 4 now.
3. Before attaching your Mounting Cups to the opening,
make sure you have correctly marked the placement of
the screw holes.
NOTE: It is important to install the gate with a spacing of
no more than 2.5" from the floor, and to make sure the gap
between the side walls and the gate is no more than 2.5"
on each side of the gate.
Position your gate in the opening so it is level and
centered as shown. Place the Mounting Cups over the
Pad of the Threaded Spindle Bolts, which should already
be fully inserted into the ends of the gate. Pull the
Threaded Spindle Bolts out until the pad and Mounting
Cup is against the wall. Take a pencil and make a light
mark on the wall around the perimeter of the Mounting
Cup. Repeat with the three remaining Spindle Bolds and
Mounting Cups. Once you have marked the correct spots
on your walls, move the gate aside.
Adjustment Wheel
Plastic Pad
3