General Guidelines - Velleman CAMSETW11 Manual De Instrucciones

2. Slide the power switch to the ON position.
3. Set the volume control to the desired level.
4. Use the channel button to
displayed on the monitor/TV. Use a video cable to connect the receiver with a monitor/TV if you want a clearer
picture.
7. Camera Channel Set-up
Remove the base of the camera and you will notice the channel switch marked with 1-2-3. You can select any one of
these e.g. you can switch channels in case of interference on the currently selected channel.
Remark: To remove the base of this camera, press and hold the back side firmly and then push it downwards.
8. Camera Alarm Set-up (fig. 5)
The camera provides either motion detection alarm or
sound detection alarm.
Motion Alarm Setup:
In this mode the device detects movement. If you slide
the alarm mode switch to IR position, the alarm indicator lights up green for 10 sec. and then extinguishes. The
function is armed after 10 sec. And the system now enters the alarm standby mode. When a movement is actually
detected, the alarm indicator lights up green again for 10 sec. and then enters the next alarm circle.
Sound Alarm Setup:
In this mode the device detects sound in excess of 75dB. If you slide the alarm mode switch to the S position, the
alarm indicator lights up red for 10 sec. and then extinguishes. The system is now in standby mode. When sound in
excess of 75dB is actually detected, the alarm indicator lights up red again for 10 sec. and then enters the next alarm
circle.
No Alarm Setup:
The alarm is not armed in this mode. If you slide the alarm mode switch to the OFF position, the alarm indicator does
not light up and the alarm function is disabled.
Remark:
When the camera is working on batteries and is subsequently connected to the mains via the adapter, then the alarm
function will not work and the alarm indicator will not light. Slide the power switch to OFF and back again to ON; the
indicator lights up and the alarm function is successfully activated.

9. General Guidelines

• Protect the device against water and don't put objects containing water (e.g. vases) on top of the device
•
Turn off the camera/receiver if the system is not in use.
•
Use the adapter to connect /disconnect the device with/from the mains.
•
Do not cut off the DC power cable to try and use it with a different power source
10. Specifications
Operating temperature
Storage temperature
Operating humidity
CAMSETW11
set the same channel on the receiver as on the camera .The camera picture is now
0 to +50°C/ +32 to +122°F
-20 to +80°C/ -4 to +176°F
85% RH
3 VELLEMAN