Publicidad
Idiomas disponibles
Idiomas disponibles
IN S TA L L AT I O N
Module Installation
Remove the module and components from the shipping
package and recycle packing materials.
Lower module into the opening. Center module with
1
the front parallel to the edge of the countertop. Using
a pencil, outline the rear edge of the module on the
countertop.
Remove module.
2
Apply the foam strip to the underside of the module
3
frame. Refer to the illustration below. Do not seal module
to the countertop.
FOAM STRIP
COUNTERTOP
CLIP
CLAMPING
BRACKET
SCREW
Module installation.
|
6
Wolf Customer Care 800.222.7820
Insert module into the opening, aligning rear edge with
4
the pencil line. Verify module is aligned with the edge of
the countertop.
To attach brackets to the sides of the module, insert
5
clips into the side punchouts and press down. Install
clamping screws into the brackets and tighten until
screws contact the underside of the countertop. Do not
overtighten. Refer to the illustration below.
Publicidad
